We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cleveland C61920 carbide end mill, .875 in diameter, 1.5 in flute length, 7/8 in shank, uncoated

Cleveland

Cleveland C61920 Carbide End Mill 0.875 in 1.5 in LOC 7/8 in SHK

SKU CH-KV1M-S62JW

Carbide square end mill with a 0.875 in diameter, 1.5 in length of cut and 7/8 in shank for general milling

  • TypeMilling
  • Carbide construction resists wear for longer tool life
  • 5 in length of cut enables deep profiling passes
  • .875 in cutting diameter suits medium-width slots
  • 7/8 in shank fits standard holders directly
  • Uncoated surface allows sharp edges on non-ferrous metals

Cleveland Carbide End Mill 0.875 in

This Cleveland carbide end mill is a square-end milling cutter built for general-purpose material removal in ferrous and non-ferrous metals. The uncoated carbide substrate handles moderate speeds and feeds without the cost premium of coated tooling. It suits job-shop machinists and maintenance teams who need a reliable cutter for profiling, slotting and facing operations on manual or CNC mills.

Replaces worn uncoated carbide square end mills

Swapping to this cutter makes sense when the existing tool shows flank wear, chipping or loss of dimensional control on 0.875 in features. The 1.5 in length of cut allows deeper axial engagement in a single pass, reducing cycle time on pockets and steps. The jump is worth it when the current tool cannot reach the required depth or when a fresh sharp edge restores finish quality on critical surfaces.

Check shank compatibility and holder clearance

Verify that your tool holder or collet accepts a 7/8 in shank diameter before ordering. Confirm the machine spindle provides enough gauge length for the 4 in overall length without interference from the workpiece or fixture. Ensure your coolant delivery method matches the non-coolant-through design, and that your programmed speeds and feeds suit uncoated carbide in the target material.

Highlights

  • Carbide construction resists wear for longer tool life
  • 5 in length of cut enables deep profiling passes
  • .875 in cutting diameter suits medium-width slots
  • 7/8 in shank fits standard holders directly
  • Uncoated surface allows sharp edges on non-ferrous metals

Specifications

BrandCLEVELAND
TypeMilling

Questions about this item

What shank diameter and overall length does this end mill need in the tool holder?

The shank is 7/8 in and the overall length is 4 in, so the holder must accept that shank size and provide enough clearance for the full length.

How is the carbide end mill secured in the spindle, and what step is often missed?

Tighten the collet or end-mill holder evenly around the 7/8 in shank; the step often missed is verifying concentric run-out before cutting.

When should the 0.875 in diameter cutter be resharpened or replaced?

Resharpen or replace when flank wear becomes visible or when surface finish and dimensional tolerance start to degrade.

More in Power & Pneumatic Accessories

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.