Cleveland
Cleveland C61902 Carbide End Mill .5 in 2 in pneumatic accessory
Carbide end mill with a .5 in diameter and 2 in length of cut for milling applications
- TypeMilling
- Carbide construction resists wear for longer tool life
- .5 inch diameter suits precise milling operations
- 2 inch length of cut enables deep material removal
- 1/2 inch shank fits standard collets and holders
- Uncoated bright finish performs well in general-purpose milling
Cleveland C61902 Carbide End Mill
The Cleveland C61902 is a solid carbide square end mill designed for general-purpose milling operations. It features a 0.5 in cutting diameter and a 2 in length of cut for efficient material removal. The uncoated finish and straight shank make it suitable for a variety of ferrous and non-ferrous materials. Overall length measures 4 in with a 1/2 in shank diameter.
Machinists needing a 0.5 in carbide end mill
This tool suits machinists performing slotting, profiling, or plunging cuts where a square corner is required. The uncoated carbide substrate performs well in shorter production runs or softer materials. Shops requiring extended tool life in abrasive alloys or high-heat applications should consider coated alternatives. Operations needing internal corner radii must select a different tool geometry.
0.5 in diameter with 2 in flute length
The cutting diameter of 0.5 in combined with a 2 in flute length defines the tool's reach and material engagement capacity. This specific ratio determines the maximum depth of cut achievable in a single pass without deflection. The 1/2 in shank diameter matches the cutting diameter for standard tool holder compatibility. Select this end mill when these exact dimensional constraints match the job requirements.
Highlights
- Carbide construction resists wear for longer tool life
- .5 inch diameter suits precise milling operations
- 2 inch length of cut enables deep material removal
- 1/2 inch shank fits standard collets and holders
- Uncoated bright finish performs well in general-purpose milling
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
How long is the cutting portion on this .5 in carbide end mill?
The length of cut is 2 in, giving a full 2 in of carbide flute for deep slotting or profiling passes.
Does the uncoated carbide run hotter or louder than coated tools during long milling sessions?
Uncoated carbide generates more friction heat and can squeal in sticky materials, so flood coolant or air blast is recommended for continuous runs.
What shank size must my collet or holder accept to use this end mill?
The shank diameter is 1/2 in, so a 1/2 in ER collet, Weldon flat holder or shrink-fit chuck with a matching bore is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
