We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cylindrical carbide end mill with 35 degree helix and 1.5 inch cutting length

Cleveland

Cleveland C61078 Carbide End Mill 35 deg 1.5 in cut 1 in shank

SKU CH-XRSW-M4Q6N

Carbide square end mill with a 35-degree helix, 1.5-inch cut length and 1-inch shank for milling operations

  • TypeMilling
  • 35-degree helix angle improves chip evacuation for smoother milling
  • Carbide construction resists wear for longer tool life
  • 5-inch cut length enables deep pocketing in one pass
  • 1-inch shank diameter fits standard tool holders directly
  • Uncoated surface suits general-purpose ferrous and non-ferrous materials

Cleveland C61078 Carbide End Mill

The Cleveland C61078 is a solid carbide square end mill designed for general-purpose milling operations. It suits machinists and fabricators who need a rigid, uncoated tool for slotting or profiling in a variety of materials.

35 degree helix with 1.5 inch cut length

A 35 degree helix angle balances chip evacuation and edge strength for smooth cutting action. The 1.5 inch length of cut provides reach for deeper pockets, while the 1 inch shank diameter ensures a secure hold in standard tool holders.

1 inch cutting diameter on carbide substrate

The 1 inch cutting diameter determines the width of each pass and the minimum internal corner radius achievable. Carbide construction delivers high wear resistance and rigidity, making this tool suitable for production runs where dimensional consistency matters.

Highlights

  • 35-degree helix angle improves chip evacuation for smoother milling
  • Carbide construction resists wear for longer tool life
  • 5-inch cut length enables deep pocketing in one pass
  • 1-inch shank diameter fits standard tool holders directly
  • Uncoated surface suits general-purpose ferrous and non-ferrous materials

Specifications

BrandCLEVELAND
TypeMilling

Questions about this item

Will the 1 in shank fit the collet on my older Bridgeport mill?

The end mill has a 1 in shank diameter, so it will fit any collet or holder sized for 1 in shanks.

How can I confirm the 35 deg helix is cutting properly once installed?

Listen for smooth, consistent chatter-free cuts and inspect the workpiece for a clean finish without built-up edge on the carbide flutes.

Does the C61078 come with a tool holder or just the carbide end mill itself?

Only the uncoated carbide end mill is supplied; a 1 in tool holder or collet must be purchased separately.

More in Power & Pneumatic Accessories

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.