Cleveland
Cleveland C61070 .75 in Carbide Corner Radius End Mill
A 0.75 in carbide corner-radius end mill with a 0.03 in radius and 1.5 in length of cut for general-purpose milling
- TypeCutting Tools
- .75 in milling diameter for wide cuts
- .03 in corner radius adds edge strength
- Carbide construction resists wear longer
- 5 in flute length reaches deeper slots
- 4 in overall length fits standard holders
Corner Radius End Mill 0.75 in
The Cleveland C61070 is a solid-carbide corner-radius end mill with a 0.75 in milling diameter. It suits machinists and maintenance shops that need a general-purpose cutter for profiling and slotting in steel or cast iron.
Two-flute uncoated carbide body
The straight shank fits standard inch collets and holders without adapters. The uncoated surface can build up edge material in sticky alloys, so flood coolant or an air blast helps maintain edge life.
0.03 in radius and 1.5 in flute length
The small 0.03 in corner radius limits the tool to light finishing passes rather than heavy roughing. The 1.5 in flute length restricts axial depth of cut, so deep pockets require multiple step-downs or a longer-reach cutter.
Highlights
- .75 in milling diameter for wide cuts
- .03 in corner radius adds edge strength
- Carbide construction resists wear longer
- 5 in flute length reaches deeper slots
- 4 in overall length fits standard holders
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Cutting Tools |
Questions about this item
How can I verify the 0.75 in diameter end mill is cutting correctly after setup?
Measure the finished corner radius against the 0.03 in specification and check for consistent chip formation across both flutes during a test cut.
What accessories come with the C61070 end mill and what must I purchase separately?
The single end mill ships alone; you will need to supply a compatible tool holder, collet or shrink-fit chuck for your machine spindle.
Which corner radius version of the 0.75 in carbide end mill should I select?
This model provides a fixed 0.03 in corner radius; choose it when that specific radius matches your part drawing requirements.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
