Cleveland
Cleveland C61034 2-Flute Carbide Square End Mill .3125 in pneumatic accessory
A 2-flute carbide square end mill with a 0.3125 inch cutting diameter and 0.5 inch length of cut
- TypeMilling
- Carbide construction resists wear for longer tool life
- Two-flute design clears chips efficiently in slotting
- .3125 in cutting diameter matches standard 5/16 in shank
- .5 in length of cut suits shallow pocketing
- 2 in overall length fits compact tool holders
Cleveland C61034 End Mill Application
The Cleveland C61034 is a 2-flute carbide square end mill designed for general-purpose milling tasks. It suits machinists and maintenance technicians who need a reliable cutting tool for slotting and profiling operations in various materials. The uncoated carbide construction provides a balance of hardness and toughness for everyday shop use.
Upgrade From High-Speed Steel Tooling
This carbide end mill replaces high-speed steel cutters when longer tool life and higher cutting speeds are required. The jump is worth it for operators running repetitive jobs where reduced tool changes improve throughput. Carbide maintains its edge better than HSS in abrasive materials, lowering the cost per part over time.
Verify Shank And Machine Compatibility
Before ordering, confirm that your tool holder or collet accepts a 5/16 in shank diameter. Check that the machine spindle provides sufficient rigidity for a 2 in overall length tool with a .5 in length of cut. Ensure your coolant setup matches the non-coolant-through design for proper chip evacuation.
Highlights
- Carbide construction resists wear for longer tool life
- Two-flute design clears chips efficiently in slotting
- .3125 in cutting diameter matches standard 5/16 in shank
- .5 in length of cut suits shallow pocketing
- 2 in overall length fits compact tool holders
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
What shank diameter does the C61034 end mill need in a collet or holder?
The shank is 5/16 in diameter, so use a matching collet or holder for a secure fit.
How do you install this carbide end mill without damaging the flutes?
Insert the shank fully into the collet, tighten evenly, and avoid side loading during the first plunge.
When should this uncoated carbide end mill be replaced?
Replace it when the cutting edges show visible wear, chipping, or when surface finish deteriorates.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
