Cleveland
Cleveland C60937 2-Flute Carbide Ball Nose End Mill
A 0.25-inch carbide ball nose end mill with two flutes for general-purpose milling
- 2-flute carbide design enables smooth contour milling
- 25 in diameter suits detailed profiling work
- Uncoated carbide performs well in non-ferrous materials
- Single-end GP style fits standard tool holders
- Ball nose geometry creates rounded-bottom slots
Cleveland C60937 ball nose end mill
The Cleveland C60937 is a two-flute carbide ball nose end mill with a 0.25 inch milling diameter. The uncoated solid carbide construction provides hardness and wear resistance for general-purpose milling. It is a single-end tool designed for contouring and profiling operations in a variety of materials.
Machinists needing uncoated carbide for general
This tool suits machinists who need an uncoated carbide end mill for general-purpose ball nose profiling and contouring. It is not for buyers who require a coated tool for higher heat resistance or extended tool life in abrasive alloys. Operators needing coolant-through capability for deep pocket evacuation should look at a different design.
0.25 inch milling diameter determines reach
The 0.25 inch milling diameter is the critical specification that decides if this end mill fits the required feature size and step-over parameters. This dimension directly controls the minimum radius achievable and the tool clearance in the workpiece. Verify this diameter matches the programming and fixturing constraints before purchase.
Highlights
- 2-flute carbide design enables smooth contour milling
- 25 in diameter suits detailed profiling work
- Uncoated carbide performs well in non-ferrous materials
- Single-end GP style fits standard tool holders
- Ball nose geometry creates rounded-bottom slots
Specifications
| Brand | CLEVELAND |
|---|
Questions about this item
What shank diameter does the .25 in ball nose end mill require?
The cutter has a .25 in milling diameter and is a single-end carbide tool designed for standard collets or end-mill holders that match that shank size.
What clearance and holder type are needed to mount this single-end carbide ball nose mill?
As a single-end uncoated carbide mill with no coolant-through feature, it fits conventional ER collets, Weldon flats, or shrink-fit holders sized for its .25 in shank.
How is this uncoated carbide ball nose end mill installed, and what step is often missed?
Secure the .25 in shank in a clean, matched collet or holder, torque to the holder maker’s spec, and verify run-out before cutting — skipping the run-out check is the common error.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
