Cleveland
Cleveland C60500 Garden Statue
A carbide square end mill with a .625 inch diameter and 1.625 inch length of cut for aluminum milling
- TypeCutting Tools
- .625 in milling diameter for precise aluminium cuts
- 625 in length of cut handles deep pockets in one pass
- Solid carbide construction resists wear in high-speed milling
- Uncoated surface prevents built-up edge on non-ferrous alloys
- Straight shank design fits standard 5/8 in tool holders
Cleveland C60500 End Mill
The Cleveland C60500 is a two-flute carbide square end mill designed for aluminium milling. It suits machinists and fabricators who need a single-end tool for general-purpose slotting and profiling in non-ferrous materials.
Uncoated Carbide Construction
The uncoated carbide substrate provides sharp edge retention in aluminium without the risk of coating delamination. A straight shank and non-coolant-through body keep the tool compatible with standard collet holders and conventional flood-coolant setups.
Verify Shank And Length Of Cut
Confirm that your holder accepts a 5/8 in shank diameter before ordering. Ensure the 1.625 in length of cut and 4 in overall length suit your machine’s work envelope and required reach.
Highlights
- .625 in milling diameter for precise aluminium cuts
- 625 in length of cut handles deep pockets in one pass
- Solid carbide construction resists wear in high-speed milling
- Uncoated surface prevents built-up edge on non-ferrous alloys
- Straight shank design fits standard 5/8 in tool holders
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Cutting Tools |
Questions about this item
When should the .625 in carbide end mill be replaced?
Replace the .625 in carbide end mill when cutting edges show visible chipping, flank wear becomes noticeable, or surface finish on aluminium deteriorates beyond acceptable limits.
What limits continuous cutting with the 1.625 in length of cut?
Heat buildup in the uncoated carbide and chip evacuation in the 1.625 in flute length become limiting factors during prolonged aluminium milling.
How much heat and noise does the 60500 end mill produce during extended runs?
The uncoated carbide generates moderate heat in aluminium; noise stays low with proper clamping and coolant, but increases if chip packing occurs in deep slots.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
