Cleveland
Cleveland C60493 2-Flute Carbide Square End Mill .4375 in
Two-flute carbide square end mill with 0.4375 inch diameter and one inch cutting length
- TypeCutting Tools
- 2-flute carbide end mill cuts aluminium cleanly
- .4375 in diameter matches standard tooling specs
- 1 in length of cut handles deep slots
- 2 1/2 in overall length fits compact holders
- 7/16 in shank secures rigidly in collets
Precision aluminium milling cutter
The Cleveland C60493 is a two-flute solid carbide square end mill built for high-performance machining of aluminium. Its uncoated geometry and straight shank suit CNC operators and job-shop machinists who need clean chip evacuation in non-ferrous materials.
7/16 in straight shank compatibility
The cutter uses a 7/16 inch diameter straight shank that must match the holder or collet bore exactly. A mismatch here causes run-out, poor finish and rapid tool wear, so verify the holder size before ordering.
Direct collet mounting with minimal setup
The plain shank drops into a standard ER or mill-chuck collet without adapters or pull-studs. The most common error is insufficient clamping length, which lets the tool pull out under heavy aluminium cuts; ensure the shank seats fully against the collet face.
Highlights
- 2-flute carbide end mill cuts aluminium cleanly
- .4375 in diameter matches standard tooling specs
- 1 in length of cut handles deep slots
- 2 1/2 in overall length fits compact holders
- 7/16 in shank secures rigidly in collets
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Cutting Tools |
Questions about this item
What does the .4375 in diameter mean when the tool is in the spindle?
The .4375 in milling diameter is the exact cutting width the tool will produce in the workpiece.
What does the straight shank with a 7/16 in diameter imply for toolholding?
The straight 7/16 in shank fits standard collets or end-mill holders sized for that diameter.
What physical space does the 2 1/2 in overall length require in the machine?
The 2 1/2 in overall length needs at least that much clearance between the spindle face and the workpiece or fixture.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
