Cleveland
Cleveland C60485 2-Flute Carbide Square End Mill .3125 in pneumatic accessory
A 2-flute carbide square end mill with a .3125 in cutting diameter and .8125 in length of cut for aluminium milling
- TypeMilling
- 2-flute design clears chips fast in aluminium
- Carbide construction resists wear for longer tool life
- .3125 in diameter matches common milling tasks
- .8125 in length of cut handles deeper slots
- Uncoated surface prevents coating buildup on soft metals
Cleveland C60485 End Mill
The Cleveland C60485 is a 2-flute carbide square end mill designed for milling operations. It suits machinists and fabricators working with aluminium and similar non-ferrous materials. The single-end configuration supports general-purpose profiling and slotting tasks. This tool is not for buyers who need coolant-through capability for deep-hole drilling.
Uncoated Carbide Construction
The solid carbide body provides high wear resistance and rigidity during high-speed machining. An uncoated finish prevents coating buildup on soft aluminium workpieces. The straight shank fits standard 5/16 inch collets and holders without adapters. Non-coolant-through design means external flood coolant or air blast must be used for chip evacuation.
0.3125 Inch Cutting Diameter
The cutting diameter measures .3125 inches with a length of cut of .8125 inches. Overall length is 2 1/2 inches allowing standard toolholder engagement. This specific diameter decides whether the tool matches the required feature size in the part program. Shops needing a different diameter or flute count must select another tool.
Highlights
- 2-flute design clears chips fast in aluminium
- Carbide construction resists wear for longer tool life
- .3125 in diameter matches common milling tasks
- .8125 in length of cut handles deeper slots
- Uncoated surface prevents coating buildup on soft metals
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
What milling diameter does the C60485 end mill use?
The C60485 has a 0.3125 in milling diameter that determines the width of each cut in aluminium.
What shank size must the tool holder accept for this end mill?
The straight shank measures 5/16 in, so the holder or collet must grip that exact diameter.
How should the 2-flute carbide end mill be secured before cutting?
Clamp the 5/16 in shank fully into a matched collet, verify zero run-out, then apply the recommended feed for aluminium.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
