Cleveland
Cleveland C60228 4-Flute Carbide Double End 90 Degree Chamfer Tool
A 90-degree carbide chamfer mill with four flutes and double-ended design for milling operations
- TypeMilling
- 4-flute design produces smooth chamfers on edges
- Carbide construction resists wear for longer tool life
- Double-ended configuration provides two cutting surfaces per tool
- 90-degree included angle creates standard chamfer profiles
- 1/4-inch milling diameter suits common workpiece dimensions
Cleveland C60228 Chamfer Mill
The Cleveland C60228 is a 4-flute carbide double-end chamfer tool designed for milling operations. It features a 90-degree included angle and a 1/4 inch milling diameter with an uncoated finish. This accessory suits machinists and fabricators who need precise edge bevelling or deburring on a range of materials. The double-end configuration provides two cutting ends per tool.
Replaces single-end chamfer mills
Switching to this double-end tool doubles the usable cutting edges compared to a single-end equivalent, reducing tool-change downtime and overall tooling cost per edge. The jump is worth it when workflow involves frequent chamfering of 90-degree angles and the operator wants to maximise carbide utilisation before replacement. Uncoated carbide performs well in general-purpose applications where specialised coatings are not required.
Limited to 90-degree included angle
This mill cuts only a fixed 90-degree included angle, so it cannot produce other chamfer angles or countersink profiles without a different tool. The 1/4 inch milling diameter sets the maximum width of the chamfer in a single pass. Users needing variable angles, larger diameters, or coated performance for abrasive alloys must select alternative tooling.
Highlights
- 4-flute design produces smooth chamfers on edges
- Carbide construction resists wear for longer tool life
- Double-ended configuration provides two cutting surfaces per tool
- 90-degree included angle creates standard chamfer profiles
- 1/4-inch milling diameter suits common workpiece dimensions
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
What shank diameter is required for the 1/4 in milling diameter?
The tool uses a 1/4 in shank to match its 1/4 in milling diameter, so a 1/4 in collet or holder is needed.
How do I install the double-end chamfer mill in the spindle?
Insert the shank fully into a 1/4 in collet, tighten the collet nut to the holder's rated torque, and verify the 90 degree included angle runs true before cutting.
When should the uncoated carbide flutes be replaced?
Replace the tool when the 4-flute cutting edges show visible wear, chipping, or when the 90 degree chamfer surface finish degrades beyond tolerance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
