Cleveland
Cleveland C54757 Straight Flute Hand Tap M14x2.00 pneumatic accessory
Straight-flute hand tap cuts M14×2.00 metric threads in high-speed steel with 42.07 mm thread length and 91.28 mm overall length
- TypeTaps
- M14x2.00 metric thread cuts precise internal threads
- High-speed steel construction resists wear during repeated tapping
- 28 mm overall length reaches deep holes easily
- 07 mm thread length engages full hole depth
- Bright uncoated finish suits general-purpose hand tapping
Straight Flute Tap M14x2.00
This Cleveland straight flute hand tap cuts metric M14 threads with a 2.00 mm pitch. It is made from high speed steel with a bright uncoated finish and a D7 thread limit for a 6H class of fit. The tool suits general purpose threading in through or blind holes.
Thermals noise and power draw
As a hand operated cutting tool it generates no electrical noise or power draw. Heat produced during tapping depends on the workpiece material and cutting speed chosen by the operator. Proper lubrication keeps temperatures low and extends tap life.
Behaviour under sustained load
The high speed steel body maintains hardness during repeated threading cycles. Chip evacuation in deep blind holes relies on the straight flute geometry and periodic withdrawal. The 42.07 mm thread length and 91.28 mm overall length give adequate reach for typical M14 applications.
Highlights
- M14x2.00 metric thread cuts precise internal threads
- High-speed steel construction resists wear during repeated tapping
- 28 mm overall length reaches deep holes easily
- 07 mm thread length engages full hole depth
- Bright uncoated finish suits general-purpose hand tapping
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Taps |
Questions about this item
How do I install the M14x2.00 straight flute hand tap and what step is often missed?
Drill the hole with a 12.00 mm bit to achieve 75 percent thread engagement, then run the tap by hand using a suitable tap wrench. The step often missed is applying cutting fluid and reversing the tap every half turn to break chips.
What maintenance or replacement will this tap need later?
The high-speed steel cutting edges will dull with use. When thread quality drops or torque rises sharply, replace the tap; there are no serviceable parts or resharpening intervals specified.
What limit appears first during sustained tapping in tough material?
Heat buildup in the uncoated high-speed steel flutes is the first limit. Extended runs without coolant reduce edge life and can cause the tap to seize in the 42.07 mm thread length.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
