Cleveland
Cleveland C54626 Straight Flute Hand Tap M10x1.5 pneumatic accessory
A straight-flute hand tap cuts M10×1.5 metric threads in through or blind holes using high-speed steel
- TypeTaps
- M10 x 1.5 metric thread fits standard holes
- Straight flute design clears chips in through holes
- High-speed steel resists wear for longer tool life
- Bright finish prevents rust without coating buildup
- 61 mm overall length reaches deep threads
M10x1.5 Straight Flute Hand Tap
The Cleveland C54626 is a straight flute hand tap designed for cutting metric M10 threads with a 1.5 mm pitch. It is intended for general-purpose threading tasks in workshop and maintenance environments. The high-speed steel construction provides durability for manual or machine-assisted tapping operations.
Capacity and thread depth
The tap has an overall length of 74.61 mm and a thread length of 31.75 mm, suitable for through holes and moderate-depth blind holes. It requires a 75 percent thread drill size of 8.50 mm for proper preparation. The D6 thread limit and 6H class of fit define the tolerance range it produces.
Upgrade from worn or undersized taps
This tap replaces dull, damaged, or incorrectly sized tooling when cutting M10x1.5 threads. The jump is worth it when existing taps no longer hold tolerance or produce clean threads in high-speed steel workpieces. It is not for buyers needing coated taps for abrasive materials or spiral-flute designs for deep blind-hole chip evacuation.
Highlights
- M10 x 1.5 metric thread fits standard holes
- Straight flute design clears chips in through holes
- High-speed steel resists wear for longer tool life
- Bright finish prevents rust without coating buildup
- 61 mm overall length reaches deep threads
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Taps |
Questions about this item
Will the M10x1.5 tap work with the 8.50 mm drill bit I already own for the 75 percent thread?
Yes, the 75 percent thread drill size is 8.50 mm, so your existing bit matches the recommended pilot hole for this M10x1.5 tap.
How can I verify the tap is cutting a correct 6H class thread after setup?
Check the finished hole with an M10x1.5 6H go/no-go gauge; the go gauge should enter fully and the no-go gauge should not pass more than two turns.
Does the box include a tap wrench or only the C54626 straight flute tap itself?
The package contains the high-speed steel straight flute tap only; a compatible tap wrench or handle must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
