Cleveland
Cleveland C54619 Straight Flute Hand Tap M10x1.25 pneumatic accessory
Straight flute hand tap cuts M10×1.25 metric threads in through or blind holes
- TypeTaps
- M10 × 1.25 metric thread for standard fastening
- Straight flute design clears chips in through holes
- High-speed steel construction resists wear during tapping
- 75 mm thread length reaches deep blind holes
- Bright uncoated finish suits general-purpose hand tapping
Cleveland M10x1.25 Straight Flute Tap
The Cleveland C54619 is a straight flute hand tap designed for creating internal M10 threads with a 1.25 mm pitch. Made from high speed steel with a bright uncoated finish, it suits general purpose threading tasks in maintenance and light fabrication workshops.
Bottoming Chamfer For Deep Holes
A bottoming chamfer allows the tap to cut threads close to the base of a blind hole. The 31.75 mm thread length on a 74.61 mm overall body provides reach for deeper bores. High speed steel construction resists wear during sustained manual or powered tapping cycles in steel and non ferrous metals.
Check Drill Size And Fit Class
Verify the 75 percent thread drill size of 11/32 inch matches your prepared hole before ordering. The D5 thread limit corresponds to a 6H class of fit for metric tolerance. Right hand cutting direction requires standard clockwise rotation. No coating means lubrication is essential for chip evacuation and tool life.
Highlights
- M10 × 1.25 metric thread for standard fastening
- Straight flute design clears chips in through holes
- High-speed steel construction resists wear during tapping
- 75 mm thread length reaches deep blind holes
- Bright uncoated finish suits general-purpose hand tapping
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Taps |
Questions about this item
Does the M10×1.25 tap run hot or draw extra air when used continuously in a pneumatic driver?
The tap itself is a passive High Speed Steel cutting tool; it produces no heat or noise and draws no air on its own — only the pneumatic driver consumes power.
What drive tool and drill bit must I already own to use this M10×1.25 bottoming tap?
You need a tap wrench or pneumatic tap driver that fits the shank, plus an 11/32 in drill bit for the 75 % thread hole before tapping.
Will this M10×1.25 D5 tap cut correct threads in an older workpiece drilled for a 6H class fit?
Yes — the tap is made to a 6H class of fit, so it matches the tolerance of existing M10×1.25 holes drilled to that same class.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
