Cleveland
Cleveland C40014 1.25 in Roughing End Mill
Roughing end mill with 1.25 in milling diameter, 6 in length of cut and 8 1/2 in overall length
- 25 in milling diameter removes material fast
- Powdered metal substrate resists wear during heavy cuts
- Three-flute design clears chips efficiently in deep slots
- Weldon flat shank locks securely in standard holders
- 8 1/2 in overall length reaches deep cavities
Cleveland C40014 Roughing End Mill
The Cleveland C40014 is a 1.25 in roughing end mill built from powdered metal HSS-E with three flutes. It suits machinists removing large volumes of material in steel, stainless steel and high-temperature alloys where a fine finish is not required.
Check shank fit and tool holder capacity
Verify that your tool holder accepts a 1 1/4 in Weldon flat shank and that the machine spindle provides enough clearance for an 8 1/2 in overall length. Ensure the 6 in length of cut matches the depth of your roughing passes.
Powdered metal construction and Weldon flat mounting
The uncoated PM+ substrate resists wear and chipping during heavy chip loads. The Weldon flat locks securely in a set-screw holder, preventing pull-out during aggressive roughing while allowing quick tool changes on the shop floor.
Highlights
- 25 in milling diameter removes material fast
- Powdered metal substrate resists wear during heavy cuts
- Three-flute design clears chips efficiently in deep slots
- Weldon flat shank locks securely in standard holders
- 8 1/2 in overall length reaches deep cavities
Specifications
| Brand | CLEVELAND |
|---|
Questions about this item
Does the Cleveland C40014 end mill come with any holders or collets, or must they be purchased separately?
The tool is supplied as a single 1.25 in roughing end mill with a Weldon flat; compatible holders or collets are sold separately.
When should I choose this 1.25 in diameter roughing end mill over other sizes?
Select the 1.25 in diameter when your operation requires that specific milling width and a 6 in length of cut on a 1 1/4 in shank.
What does the 6 in length of cut mean for actual machining?
It allows up to 6 in of axial material removal in a single pass, limited by machine rigidity and coolant access.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
