We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cleveland C40007 PM End Mill .75 in diameter 1.625 in length of cut uncoated powdered metal Weldon flat shank

Cleveland

Cleveland C40007 PM End Mill .75 in 1.625 in LOC

SKU CH-608N-NFC1G

Powdered metal roughing end mill with 0.75 in diameter and 1.625 in length of cut for milling operations

  • TypeMilling
  • Powdered metal construction resists wear during heavy milling cuts
  • .75 inch diameter matches standard tool holders for quick setup
  • 625 inch length of cut removes more material per pass
  • Uncoated surface suits a wide range of workpiece materials
  • Weldon flat shank prevents slippage under high torque loads

Cleveland C40007 PM End Mill

The Cleveland C40007 is a powdered metal roughing end mill designed for material removal in milling operations. It features a 0.75 in milling diameter and a 1.625 in length of cut. The tool has a Weldon flat on a 3/4 in shank for secure holder retention. Overall length measures 3 7/8 in for standard machine compatibility.

Suited for rough milling tasks.

This end mill suits machinists performing heavy roughing cuts where rapid stock removal is the priority. The uncoated powdered metal substrate handles general-purpose milling in softer materials. Shops requiring fine surface finishes or high-speed profiling in hardened alloys should select a dedicated finishing tool instead. The lack of coating limits heat resistance in aggressive parameters.

0.75 in diameter with 1.625 in length of cut

The 0.75 in cutting diameter paired with a 1.625 in length of cut defines the reach and width of each milling pass. This specific ratio determines whether the tool can access the required feature depth without deflection. Verify these two dimensions against your part geometry and fixture clearance before purchase.

Highlights

  • Powdered metal construction resists wear during heavy milling cuts
  • .75 inch diameter matches standard tool holders for quick setup
  • 625 inch length of cut removes more material per pass
  • Uncoated surface suits a wide range of workpiece materials
  • Weldon flat shank prevents slippage under high torque loads

Specifications

BrandCLEVELAND
TypeMilling

Questions about this item

How do I install the 3/4 in Weldon flat shank, and what step do people skip?

Insert the .75 in shank into a matching Weldon holder, align the flat with the set-screw, then tighten the screw firmly on the flat — skipping the alignment check lets the tool spin in the holder.

What maintenance or replacement will this uncoated powdered-metal end mill need?

The cutting edges will dull; resharpen the flutes on a tool-and-cutter grinder or replace the mill when corner wear exceeds tolerance.

What limit appears first during a long roughing cut with the 1.625 in length of cut?

Chip evacuation in the deep flutes becomes the bottleneck — pack the flutes and the tool will deflect or break before heat builds up.

More in Power & Pneumatic Accessories

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.