Cleveland
Cleveland C30800 Chucking Reamer 3/4 in HSS Spiral
A high-speed steel chucking reamer with a straight spiral flute for finishing 3/4 inch fractional holes
- TypeReamers
- High-speed steel construction resists wear during repeated reaming
- Spiral flutes evacuate chips efficiently for smoother hole finishes
- Bright uncoated surface reduces friction on ferrous and non-ferrous metals
- Straight shank fits standard chucks for quick tool changes
- Fractional 3/4 inch size matches common automotive and machine-shop specifications
Cleveland C30800 Chucking Reamer 3/4 in HSS Spiral
The Cleveland C30800 is a fractional-inch chucking reamer made from high-speed steel with a bright, uncoated finish. It is designed for machinists and maintenance technicians who need to enlarge or finish existing holes to precise diameters in a variety of ferrous and non-ferrous materials.
Capacity and headroom: 3/4 inch finish
The 3/4 inch cutting diameter determines the final hole size this tool produces. Its straight shank fits standard chucks and collets for secure holding in drill presses, lathes, or milling machines. The high-speed steel construction provides the hardness and wear resistance needed for general-purpose reaming, while the spiral flute geometry aids chip evacuation in through-holes; however, the straight flute limit means chip packing can occur in deep blind holes.
Bundled accessories and software impact
This reamer is supplied as a single cutting tool with no additional accessories, coatings, or software included. The bright uncoated surface means the user must supply appropriate cutting fluid or lubricant to manage heat and extend tool life. No pilot drills, bushings, or storage cases are provided, so operators must source compatible holders and measuring instruments separately.
Highlights
- High-speed steel construction resists wear during repeated reaming
- Spiral flutes evacuate chips efficiently for smoother hole finishes
- Bright uncoated surface reduces friction on ferrous and non-ferrous metals
- Straight shank fits standard chucks for quick tool changes
- Fractional 3/4 inch size matches common automotive and machine-shop specifications
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Reamers |
Questions about this item
Will this C30800 reamer fit the straight-shank chuck on my older drill press?
The Cleveland C30800 has a straight shank designed for standard chucking reamer holders and drill press chucks.
How can I verify the C30800 is cutting to the correct 3/4 inch diameter after setup?
Measure the finished hole with a calibrated micrometer or bore gauge; a properly running reamer should produce a hole within standard HSS reamer tolerance for 3/4 inch.
Does the C30800 come with a protective tube or do I need to buy storage separately?
The reamer is supplied as a single High Speed Steel cutting tool; protective tubes, cases or lubricants are not included and must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
