Cleveland
Cleveland C25408 Chucking Reamer No 5 HSS Straight
High-speed steel chucking reamer in straight wire size #5 for precision hole finishing
- TypeReamers
- High-speed steel construction resists wear during repeated use
- Bright uncoated finish suits general-purpose reaming tasks
- Straight shank fits standard chucks without adapters
- Wire gauge #5 size targets precise hole finishing
- Cleveland brand backs professional-grade tool reliability
Cleveland C25408 Chucking Reamer
The Cleveland C25408 is a #5 size chucking reamer manufactured from high-speed steel. It features a straight shank and straight flute geometry with a bright uncoated finish. This cutting tool is designed for precision hole finishing in machine shop and maintenance applications.
For precision hole enlargement
This reamer suits machinists and technicians who need to bring a pre-drilled hole to final diameter with a tight tolerance. It is not intended for primary drilling or for removing large amounts of material in a single pass. Buyers who need a coated tool for extended life in abrasive alloys should look at alternative surface treatments.
#5 wire gauge size
The single specification that determines fit is the #5 wire gauge diameter. The reamer will only produce the correct hole size for this specific designation. Verify the required wire gauge number against your engineering drawing or parts list before ordering.
Highlights
- High-speed steel construction resists wear during repeated use
- Bright uncoated finish suits general-purpose reaming tasks
- Straight shank fits standard chucks without adapters
- Wire gauge #5 size targets precise hole finishing
- Cleveland brand backs professional-grade tool reliability
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Reamers |
Questions about this item
Will the Cleveland C25408 chucking reamer fit in the same drill chuck I already use for standard bits?
The straight shank on this #5 wire-size reamer seats in any standard three-jaw chuck that accepts round tooling of that diameter.
How can I confirm the Cleveland C25408 reamer is cutting correctly after I install it?
A clean, round hole at the exact #5 wire gauge with smooth walls and no chatter shows the high-speed steel flutes are engaging properly.
Does the Cleveland C25408 reamer come with a protective sleeve or cutting fluid, or must I buy those separately?
The tool ships as the bare bright-finish reamer only; sleeves, cutting fluid and any holders are separate purchases.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
