Cleveland
Cleveland C24281 Taper Pin Reamer No 5 Bright Spiral pneumatic accessory
A bright spiral-fluted taper-pin reamer for enlarging and finishing 1/4 in holes
- TypeReamers
- Bright finish resists corrosion for longer tool life
- Spiral flute design clears chips efficiently during reaming
- Taper pin reamer sizes holes for precise pin fitting
- Number 5 size matches standard taper pin specifications
- Cleveland brand delivers reliable performance in pneumatic applications
Cleveland C24281 Taper Pin Reamer
The Cleveland C24281 is a bright-finish spiral reamer designed to enlarge and finish tapered holes for standard taper pins. It suits maintenance technicians and machinists who need accurate fits in steel or softer metals during assembly or repair work.
Straight-shank helical installation
The straight shank fits directly into a drill chuck or collet without adapters, and the helical flutes pull chips forward to reduce binding. Problems arise if the workpiece is not rigidly clamped or if cutting fluid is omitted, causing chatter or oversized holes.
Quarter-inch capacity and headroom
The reamer comfortably handles a 1/4 inch taper pin size, giving clean results in through-holes of moderate depth. It runs out on larger diameters, blind holes or hardened materials where flute length and chip evacuation become limiting factors.
Highlights
- Bright finish resists corrosion for longer tool life
- Spiral flute design clears chips efficiently during reaming
- Taper pin reamer sizes holes for precise pin fitting
- Number 5 size matches standard taper pin specifications
- Cleveland brand delivers reliable performance in pneumatic applications
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Reamers |
Questions about this item
How can I confirm the Cleveland C24281 reamer is cutting correctly after setup?
The reamer should produce a smooth, consistent helical cut in the tapered hole without chatter; the bright finish will show even wear along the spiral flutes when it is working properly.
What comes with the Cleveland C24281 taper pin reamer and what must I supply?
The package contains only the No 5 bright spiral reamer itself; you must provide the pneumatic or power tool drive, suitable collet or chuck, cutting lubricant and the workpiece.
Which version of the Cleveland C24281 should I choose for a standard 1/4 inch taper pin?
The listed C24281 is a single No 5 size reamer designed for 1/4 inch straight helical reaming; there are no alternative capacities or versions offered for this model.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
