Cleveland
Cleveland C24262 Taper Pin Reamer No 7 Size Bright Straight 21/64 in
Straight-flute taper-pin reamer sized 21/64 inch for precision hole finishing
- TypeReamers
- Taper-pin reamer cuts precise holes for secure fits
- Straight-flute design removes chips cleanly in through-holes
- Bright finish reduces friction and resists corrosion
- Number-7 size matches standard 21/64 inch taper pins
- Cleveland tooling built for professional workshop reliability
Cleveland C24262 Taper Pin Reamer No 7
This Cleveland C24262 taper pin reamer is a straight-fluted cutting tool sized at 21/64 in for finishing tapered holes. It suits maintenance technicians and machinists who need accurate fits for standard taper pins in assembly work. The bright finish indicates uncooled high-speed steel ready for general-purpose use. Buyers needing spiral flutes or a different diameter must select another tool.
Sustained cutting behaviour
Under continuous hand or light machine feed the straight flutes evacuate chips in a linear path, so heat builds steadily rather than in spikes. The tool holds size as long as the workpiece material and lubrication remain consistent. Operators who run long production batches without coolant will see faster edge wear than those who pause for oil.
Installation and common issues
The reamer fits any standard tap wrench or machine spindle that accepts a straight shank of this diameter. Misalignment is the main cause of oversize or bell-mouthed holes; starting the cut square prevents it. Dull edges from prior use on hard steel will push rather than cut, so inspect the flutes before each job.
Highlights
- Taper-pin reamer cuts precise holes for secure fits
- Straight-flute design removes chips cleanly in through-holes
- Bright finish reduces friction and resists corrosion
- Number-7 size matches standard 21/64 inch taper pins
- Cleveland tooling built for professional workshop reliability
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Reamers |
Questions about this item
How much heat does the Cleveland C24262 generate during extended reaming sessions?
The bright-finish high-speed steel runs cool with proper cutting fluid; heat build-up stays low enough for continuous hand or light machine use.
What shank or holder does the 21/64 in reamer need to fit my drill or reaming machine?
The straight shank matches standard 21/64 in drill chucks and collets, so any 1/2 in or larger capacity holder works.
Will the No 7 taper pin reamer clean up holes drilled with older fractional bits?
Yes — the 21/64 in cutting diameter follows standard taper-pin geometry, correcting undersize or misaligned holes from legacy tooling.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
