Cleveland
Cleveland 96041 Spiral Point Tap M8x1.25 3 Flutes 90mm pneumatic accessory
Metric spiral-point tap cuts M8×1.25 threads in through-holes, 90 mm overall with 35 mm thread length, three-flute cobalt steel and Hard Lube coating for chip evacuation
- Spiral point design pushes chips forward for cleaner threading
- M8 x 1.25 metric thread fits standard applications
- Three flutes balance strength and chip clearance
- Cobalt construction with Hard Lube coating resists wear
- 90 mm overall length with 35 mm thread reach
Cleveland M8 Spiral Point Tap
The Cleveland 96041 spiral point tap cuts M8x1.25 metric threads in through-hole applications. Its cobalt construction with Hard Lube coating resists wear during repetitive use. The tool suits maintenance technicians and small-shop machinists who need reliable thread production in steel or stainless alloys.
90 mm length with 35 mm thread section
The 90 mm overall length provides reach for deeper holes while the 35 mm thread length defines the cutting zone. Three flutes evacuate chips ahead of the tap, reducing torque and breakage risk. The 75 percent thread drill size H prepares the hole for a 6H class of fit, leaving no margin for oversize threads or heavy-load fastening.
Plug chamfer limits blind-hole use
The plug-style chamfer requires clearance beyond the hole bottom, so the tap cannot thread to the bottom of a blind hole. Right-hand cutting direction matches standard metric fasteners. Cobalt substrate handles higher temperatures than high-speed steel but still demands proper lubrication and alignment to avoid premature dulling.
Highlights
- Spiral point design pushes chips forward for cleaner threading
- M8 x 1.25 metric thread fits standard applications
- Three flutes balance strength and chip clearance
- Cobalt construction with Hard Lube coating resists wear
- 90 mm overall length with 35 mm thread reach
Specifications
| Brand | CLEVELAND |
|---|
Questions about this item
Will the 90 mm overall length clear the chuck on my older pneumatic tapping head?
The tap is 90 mm long overall with a 35 mm thread length, so measure your chuck depth against those dimensions before use.
How can I confirm the 6H class of fit is cutting correctly on the first hole?
Run a 6H go/no-go gauge on the finished M8×1.25 thread; the go member should enter fully and the no-go should stop within three turns.
Does the box include the matching H-size drill bit or only the three-flute cobalt tap?
Only the spiral-point tap is supplied; the 75 % thread drill size H bit must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
