Cleveland
Cleveland 81065 0.625 in Carbide Corner Radius End Mill
Carbide corner-radius end mill with a .625 in diameter, .09 in radius and 1.25 in flute length for general-purpose milling
- TypeCutting Tools
- 625 in diameter handles medium milling jobs
- 09 in corner radius strengthens edges and reduces chipping
- Carbide construction resists wear for longer tool life
- TiAlN coating lowers friction and extends cutting performance
- 25 in flute length supports deeper cuts in one pass
Cleveland 81065 Carbide End Mill
The Cleveland 81065 is a 0.625 in carbide corner-radius end mill built for general-purpose milling. Two flutes and a TiAlN coating suit machinists and job-shop operators who need reliable material removal in steel and other alloys. The straight-shank, inch-dimensioned tool fits standard holders without adapters.
Upgrade from uncoated or multi-flute tools
Replacing uncoated high-speed steel cutters with this carbide body and TiAlN layer raises heat resistance and edge life. The jump is worth it when cycle times must drop or when harder workpiece grades dull lesser tools too quickly. The .09 in corner radius also reduces chipping compared with sharp-corner alternatives.
Steady cutting under sustained load
Carbide rigidity and the TiAlN surface keep flute temperature stable during extended passes at 1.25 in length of cut. The 3 1/2 in overall length provides reach without excessive deflection, so dimensional accuracy holds through long roughing sequences. Chip evacuation stays consistent because the two-flute geometry clears volume efficiently at recommended feed rates.
Highlights
- 625 in diameter handles medium milling jobs
- 09 in corner radius strengthens edges and reduces chipping
- Carbide construction resists wear for longer tool life
- TiAlN coating lowers friction and extends cutting performance
- 25 in flute length supports deeper cuts in one pass
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Cutting Tools |
Questions about this item
What shank diameter does the 81065 end mill need in a tool holder?
The 81065 has a 0.625 in shank that matches standard 5/8 in collets and end-mill holders.
How deep can the 81065 cut in a single pass without deflection?
The flute length is 1.25 in, so plan your depth of cut within that length and use rigid setups to avoid chatter.
When should the 81065 be replaced or re-sharpened?
Replace or re-sharpen when the 0.09 in corner radius shows visible wear or when surface finish degrades on the workpiece.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
