Cleveland
Cleveland 80184 0.4375 in Carbide Square Double-End End Mill
A carbide square double-end mill with 0.4375 in diameter and 0.875 in length of cut for general-purpose milling
- TypeCutting Tools
- Square end for precise profiling cuts
- 4375 in milling diameter suits medium slots
- Carbide construction resists wear in steel
- TiAlN coating extends tool life at speed
- Double-end design gives two cutting edges
Cleveland 80184 Carbide End Mill
The Cleveland 80184 is a solid-carbide square end mill with two flutes and cutting edges on both ends. It suits machinists who need a general-purpose tool for slotting, profiling and finishing in steel, cast iron and non-ferrous alloys. The TiAlN coating adds heat resistance for dry or light-mist machining.
Sustained cutting behaviour
The .4375 in diameter and .875 in length of cut give a rigid cross-section that resists deflection during long passes. Carbide holds its edge at higher temperatures than high-speed steel, so feed rates stay consistent without frequent tool changes. The double-ended design effectively doubles tool life when one end wears.
Installation notes
The straight 1/2 in shank fits standard ER collets, Weldon flats or shrink-fit holders without adapters. Run-out must be checked after clamping because excess overhang amplifies vibration at the longer 4 in overall length. Coolant-through is not supported, so external flood or mist must reach the flutes directly.
Highlights
- Square end for precise profiling cuts
- 4375 in milling diameter suits medium slots
- Carbide construction resists wear in steel
- TiAlN coating extends tool life at speed
- Double-end design gives two cutting edges
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Cutting Tools |
Questions about this item
How much heat does the 0.4375 in carbide end mill generate during continuous milling?
The solid carbide body and TiAlN coating reduce friction, so the tool runs cooler than uncoated steel cutters during extended cuts.
What machine and holder are needed to run this 1/2 in shank double-end mill?
A milling machine or CNC with a 1/2 in collet or end-mill holder and sufficient rigidity for a 4 in overall length tool.
Will this 0.875 in length-of-cut tool reach the same depths as my older 3 in long end mills?
Its 4 in overall length and 0.875 in flute length provide less reach, so deep pockets may require a longer tool or an extension holder.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
