Cleveland
Cleveland 61043 Carbide End Mill 0.375 in 0.03 in Corner Radius
A 0.375 in carbide corner-radius end mill with a 0.03 in radius for general-purpose milling
- TypeCutting Tools
- Carbide construction resists wear for longer tool life
- Two-flute design clears chips efficiently in slotting operations
- 03 in corner radius strengthens edges against chipping
- 375 in cutting diameter suits a range of milling tasks
- Uncoated surface performs well in non-ferrous and general-purpose materials
Cleveland 61043 Carbide End Mill
This carbide end mill features a 0.375 in milling diameter and a 0.03 in corner radius for precise profiling. The uncoated, two-flute design suits general-purpose milling in non-ferrous materials and plastics. It is intended for machinists and fabricators needing a sharp, rigid tool for light finishing passes.
Capacity and headroom with 1 in length of cut
The 1 in flute length provides adequate reach for shallow pockets and side milling operations. The 2 1/2 in overall length fits standard tool holders without excessive overhang. The tool runs out when deeper cavities or heavy roughing require longer flutes or coated substrates for heat resistance.
Upgrade from high-speed steel or worn cutters
This carbide end mill replaces high-speed steel tools that dull quickly in abrasive composites or aluminium alloys. The jump is worth it when longer tool life and tighter tolerances reduce tool changes on repeat jobs. It does not serve buyers who need extended reach for deep pockets or coated performance in hardened steels.
Highlights
- Carbide construction resists wear for longer tool life
- Two-flute design clears chips efficiently in slotting operations
- 03 in corner radius strengthens edges against chipping
- 375 in cutting diameter suits a range of milling tasks
- Uncoated surface performs well in non-ferrous and general-purpose materials
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Cutting Tools |
Questions about this item
Will this .375 in end mill work with my existing tool holders?
The .375 in milling diameter fits standard inch-size holders, so it will seat in any collet or chuck made for that shank size.
How do I verify the .03 in corner radius is cutting correctly after setup?
Measure the finished corner with a radius gauge or profile comparator; a true .03 in radius should match the gauge without steps or flats.
Does the box include any collets or tool holders?
Only the single uncoated carbide end mill is supplied; collets, holders and coolant accessories must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
