Cle-Line
Cle-Line C23131 135 Degree Jobber Length Drill Bit 5/32 in
A 5/32 inch high-speed steel jobber drill bit with a 135-degree split point for accurate starting
- TypeDrill Bits
- MaterialHAWA
- 135° split point reduces walking on hard materials
- High-speed steel construction resists wear during repetitive drilling
- Black oxide finish lowers friction and improves chip flow
- 5/32 in diameter with .1563 decimal equivalent for precise sizing
- Jobber length balances rigidity and reach for general use
Cle-Line C23131 5/32 in Drill Bit
This Cle-Line C23131 is a 5/32 in jobber length drill bit made from high speed steel with a black oxide finish. It features a 135 degree split point for accurate starting and reduced walking. The decimal equivalent is .1563 in. It is designed for general purpose drilling applications.
Suits metalworkers needing split point accuracy
Buyers who need coolant-through capability should look elsewhere as this bit has zero coolant holes. It is a fractional inch tool so metric-only workshops cannot use it directly. The 135 degree point angle suits hard materials but may not suit soft plastics.
135 degree split point decides fit
The 135 degree split point geometry determines whether this bit matches the material hardness and precision requirements of the job. Verify the 5/32 in fractional size and .1563 decimal equivalent against the drawing before ordering.
Highlights
- 135° split point reduces walking on hard materials
- High-speed steel construction resists wear during repetitive drilling
- Black oxide finish lowers friction and improves chip flow
- 5/32 in diameter with .1563 decimal equivalent for precise sizing
- Jobber length balances rigidity and reach for general use
Specifications
| Brand | CLE-LINE |
|---|---|
| Type | Drill Bits |
| Material | HAWA |
Questions about this item
What chuck size do I need to hold the 5/32 inch shank?
A standard three-jaw chuck that opens to at least 5/32 inch (0.1563 decimal) will grip the bit securely.
Will the 135 degree split point start cleanly in the harder steels I still machine on my older drill press?
Yes, the 135 degree split point is designed to self-center and reduce walking on tough materials including high-strength alloys.
How can I confirm the bit is cutting correctly once installed?
The bit should produce short, curled chips and advance smoothly without excessive pressure or squealing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
