Cle-Line
Cle-Line C22738 118° Jobber Drill Bit Q .3320
Q-size jobber drill bit with a 118-degree point in high-speed steel for general-purpose drilling
- TypeDrill Bits
- MaterialHAWA
- 118° point angle centres quickly on contact
- High-speed steel body resists heat during drilling
- Black oxide finish reduces friction and chip welding
- Letter size Q matches .3320 decimal specification
- Jobber length gives standard reach for general tasks
Cle-Line C22738 Jobber Drill Bit
The Cle-Line C22738 is a jobber-length drill bit sized to the letter Q with a decimal equivalent of .3320. It is made from high-speed steel with a black oxide finish and a 118-degree conventional point. This bit suits general-purpose drilling in metal, wood and plastic for maintenance and fabrication tasks.
Replaces worn or undersized general-purpose bits
When an existing bit no longer cuts cleanly or the required hole size falls between standard fractional sizes, the letter-size Q fills the gap. The 118-degree point geometry matches common shop practice, so the switch requires no change in technique or equipment.
Handles general-purpose drilling in steel.
The high-speed steel body and black oxide finish give adequate wear resistance for routine holes up to .3320 diameter. The non-coolant-through design and conventional point limit performance in deep-hole or high-volume production work where through-coolant or split-point bits are preferred.
Highlights
- 118° point angle centres quickly on contact
- High-speed steel body resists heat during drilling
- Black oxide finish reduces friction and chip welding
- Letter size Q matches .3320 decimal specification
- Jobber length gives standard reach for general tasks
Specifications
| Brand | CLE-LINE |
|---|---|
| Type | Drill Bits |
| Material | HAWA |
Questions about this item
What size drill chuck is needed for the .3320 inch diameter shank?
A standard 3/8 inch or larger drill chuck will accept the .3320 inch shank on this jobber length bit.
How should the 118 degree conventional point be started to avoid walking?
Use a centre punch mark and light pressure at low speed until the 118 degree point seats itself in the workpiece.
When does the black oxide coating on the high speed steel indicate the bit should be replaced?
Replace the bit once the black oxide wears off the cutting lips or the 118 degree point shows visible rounding.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
