Cle-Line
Cle-Line C22717 15/64 in 118° Jobber Drill Bit
A 15/64 inch jobber drill bit with a 118 degree point angle made from high speed steel with black oxide finish
- TypeDrill Bits
- MaterialHAWA
- 15/64 in diameter drills precise fractional holes
- 118° conventional point centres quickly in steel
- High-speed steel body resists wear under load
- Black oxide finish reduces friction and corrosion
- Jobber length reaches deep into workpieces
General-purpose jobber drill bit
The Cle-Line C22717 is a fractional-inch jobber drill bit sized at 15/64 in with a 118-degree conventional point. It is made from high-speed steel with a black oxide finish for general-purpose drilling in metal, wood and plastic.
High-speed steel construction
The high-speed steel body resists heat build-up during normal drilling operations while the black oxide coating reduces friction and improves chip flow. The 118-degree point angle centres easily on flat surfaces without walking.
Standard shank fits common chucks
The straight shank fits standard three-jaw drill chucks and quick-change adapters used in hand-held and bench-top drills. The jobber length provides a practical reach for through-holes and deep drilling without requiring specialised tool holders.
Highlights
- 15/64 in diameter drills precise fractional holes
- 118° conventional point centres quickly in steel
- High-speed steel body resists wear under load
- Black oxide finish reduces friction and corrosion
- Jobber length reaches deep into workpieces
Specifications
| Brand | CLE-LINE |
|---|---|
| Type | Drill Bits |
| Material | HAWA |
Questions about this item
How do I install the Cle-Line C22717 15/64 in drill bit in my drill chuck, and what step do people often miss?
Open the chuck jaws wide enough for the 15/64 in shank, insert the bit fully until it seats, then tighten securely; the step often missed is checking that the bit runs true before drilling.
What maintenance or replacement will the Cle-Line C22717 15/64 in bit need later?
The high-speed steel cutting edges will dull with use; resharpen the 118° conventional point to the original angle or replace the bit when the black oxide coating wears off and cutting performance drops.
What limit appears first on the Cle-Line C22717 15/64 in bit during sustained drilling?
Heat buildup at the 118° point is the first limit because the bit has no coolant holes; reduce feed pressure and use cutting fluid to prevent the high-speed steel from overheating and losing hardness.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
