Cle-Line
Cle-Line C22686 #25 118° Jobber Drill Bit 1899
A #25 jobber-length drill bit with a 118-degree point and 0.1495-inch diameter, made from high-speed steel with a black-oxide finish
- TypeDrill Bits
- MaterialHAWA
- #25 wire size for precise pilot holes
- 118° conventional point starts cleanly without walking
- High-speed steel body resists wear in general-purpose drilling
- Black oxide finish reduces friction and corrosion
- 1495 in decimal equivalent matches exact specifications
Cle-Line #25 Jobber Drill Bit
The Cle-Line #25 jobber drill bit is a general-purpose cutting tool made from high speed steel with a black oxide finish. It features a 118 degree conventional point angle and a decimal equivalent of 0.1495 inches. The bit is designed for standard drilling tasks in metal and other materials without coolant-through capability.
Installation and common issues
The bit installs in any standard drill chuck that accepts its shank diameter. Because it lacks coolant holes, overheating can occur during deep or high-speed drilling unless cutting fluid is applied externally. The conventional point may walk on hard or smooth surfaces, so a centre punch mark is advisable before starting the hole.
Capacity and headroom
This #25 wire gauge size handles light to medium duty holes in steel, aluminium and plastic where a 0.1495 inch diameter is required. The jobber length provides adequate reach for typical through holes but runs out of flute length for very deep holes or high-volume production where coolant-through tooling would be necessary.
Highlights
- #25 wire size for precise pilot holes
- 118° conventional point starts cleanly without walking
- High-speed steel body resists wear in general-purpose drilling
- Black oxide finish reduces friction and corrosion
- 1495 in decimal equivalent matches exact specifications
Specifications
| Brand | CLE-LINE |
|---|---|
| Type | Drill Bits |
| Material | HAWA |
Questions about this item
How can I confirm the drill bit is performing correctly after first use?
Check that the 118-degree conventional point produces clean, round holes in steel without wandering and that the black oxide finish resists excessive wear during the initial drilling tasks.
What comes in the package and what additional items are required?
The package contains the Cle-Line C22686 #25 jobber drill bit made of high speed steel with black oxide coating; a compatible drill chuck or collet to hold the 0.1495-inch shank must be supplied separately.
Which version of this drill bit should I select for general-purpose metal drilling?
Choose the C22686 model with 118-degree point angle and jobber length, as it is designed for general-purpose drilling in steel and other ferrous materials.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
