Cle-Line
Cle-Line C22683 118 Degree Jobber Length Drill Bit 9/64 in
A 9/64 inch high-speed steel jobber drill bit with a 118-degree point angle and black oxide finish for general-purpose drilling
- TypeDrill Bits
- MaterialHAWA
- 118-degree point angle centres the bit quickly
- 9/64 inch fractional size matches common pilot-hole needs
- High-speed steel construction resists heat during drilling
- Black oxide finish reduces friction and adds corrosion resistance
- Jobber length gives standard reach for general-purpose work
Product Identity
The Cle-Line C22683 is a jobber length drill bit sized at 9/64 inch with a 118 degree conventional point. It is made from high speed steel with a black oxide finish for general purpose drilling tasks.
Installation Notes
The straight shank fits standard drill chucks without special adapters or coolant connections. The conventional point starts easily on flat surfaces but may wander on curved or hardened materials without a centre punch mark.
Practical Limits
The 118 degree point angle suits mild steel, aluminium and plastics rather than tough alloys or deep holes. The black oxide coating aids chip flow and reduces galling but does not replace cutting fluid in sustained operations.
Highlights
- 118-degree point angle centres the bit quickly
- 9/64 inch fractional size matches common pilot-hole needs
- High-speed steel construction resists heat during drilling
- Black oxide finish reduces friction and adds corrosion resistance
- Jobber length gives standard reach for general-purpose work
Specifications
| Brand | CLE-LINE |
|---|---|
| Type | Drill Bits |
| Material | HAWA |
Questions about this item
How do I confirm the 118 degree point angle is cutting correctly after setup?
The 118 degree conventional point should centre quickly and produce consistent chips in steel when run at the proper speed for high speed steel.
What comes in the box with the Cle-Line C22683 drill bit?
The box contains the single 9/64 inch jobber length drill bit made of high speed steel with black oxide finish.
Which fractional size matches the .1406 decimal equivalent listed for this bit?
The .1406 decimal equivalent corresponds to the 9/64 inch fractional size of this jobber length drill bit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
