Cle-Line
Cle-Line C22505 118 Degree 25/64 in Jobber Length Drill Bit
A 25/64 inch jobber length drill bit with a 118 degree point angle made from high speed steel with black oxide finish
- TypeDrill Bits
- MaterialHAWA
- 118° point angle centres quickly on metal
- High-speed steel resists wear in general drilling
- Black oxide finish reduces friction and heat
- 25/64 in diameter matches common fractional sizes
- Jobber length provides standard reach for drill presses
Cle-Line C22505 118° 25/64" Jobber Drill Bit
The Cle-Line C22505 is a fractional-inch jobber length drill bit sized at 25/64 inch with a decimal equivalent of 0.3906. It features a conventional 118-degree point angle and a black oxide finish on high speed steel. This general-purpose bit suits maintenance technicians and metalworkers drilling mild steel, cast iron or non-ferrous alloys in a workshop or on-site.
Straight-shank design fits standard drill chucks
The straight shank seats directly in any three-jaw chuck matching the 25/64 inch diameter, so no special adapters or collets are required. Because the bit is non-coolant-through with zero coolant holes, chips must clear the flutes unaided; deep holes in sticky materials can pack flutes and cause wandering or breakage if peck drilling and cutting fluid are neglected.
Verify chuck capacity and material suitability
Confirm the drill chuck opens to at least 25/64 inch before ordering, as smaller chucks cannot grip this shank. The 118-degree conventional point is optimised for general-purpose metal cutting rather than hard abrasives or precision woodwork, so match the bit to the intended workpiece hardness and hole tolerance requirements.
Highlights
- 118° point angle centres quickly on metal
- High-speed steel resists wear in general drilling
- Black oxide finish reduces friction and heat
- 25/64 in diameter matches common fractional sizes
- Jobber length provides standard reach for drill presses
Specifications
| Brand | CLE-LINE |
|---|---|
| Type | Drill Bits |
| Material | HAWA |
Questions about this item
How can I confirm the 118-degree point angle is cutting correctly after I start drilling?
The 118-degree conventional point should centre itself without a pilot hole and produce clean, even chips in steel when the bit is running at the proper speed.
What comes in the package and do I need to buy a holder or coolant system separately?
The box contains the single 25/64-inch jobber-length drill bit; it has no coolant holes, so no coolant-through holder is required and a standard drill chuck is all you need.
Which size should I choose if the drawing calls for a 0.3906-inch hole?
The 25/64-inch fractional size has a decimal equivalent of .3906, so it matches that specification exactly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
