Cle-Line
Cle-Line C18022 13/32 in 135 Degree Heavy-Duty Jobber Length Drill Bit Black & Gold
A 13/32 inch high-speed steel jobber drill bit with a 135-degree split point for accurate starts in metal
- TypeDrill Bits
- 135-degree split point starts holes fast
- 13/32 inch diameter drills precise fractional holes
- High-speed steel body resists wear
- Black-and-gold finish reduces friction
- Jobber length reaches standard depths
Cle-Line C18022 13/32 in Drill Bit
The Cle-Line C18022 is a jobber length drill bit manufactured from high speed steel with a black and gold surface treatment. It features a 135 degree split point designed for accurate starting without a centre punch. The fractional size is 13/32 inch with a decimal equivalent of 0.4063 inch.
Suited for general machine drilling in metal
This bit suits mechanics and maintenance technicians who need a durable, general-purpose drill for ferrous and non-ferrous materials. The split point geometry reduces walking on flat surfaces. Buyers who need coolant-through capability or a different point angle for specialised alloys should look at alternative designs.
135 degree split point angle
The 135 degree split point is the specification that determines suitability for a given task. It provides self-centring performance and lower thrust requirements compared to standard points. This geometry is the deciding factor when selecting a bit for efficient drilling in harder materials without pilot holes.
Highlights
- 135-degree split point starts holes fast
- 13/32 inch diameter drills precise fractional holes
- High-speed steel body resists wear
- Black-and-gold finish reduces friction
- Jobber length reaches standard depths
Specifications
| Brand | CLE-LINE |
|---|---|
| Type | Drill Bits |
Questions about this item
Does the 135-degree split point reduce wandering on hard steel?
Yes, the 135-degree split point is designed to start on contact and reduce walking on tough materials like stainless steel.
Will the 13/32-inch shank fit a standard three-eighths drill chuck?
No, the 13/32-inch diameter (0.4063 in) exceeds the typical three-eighths-inch chuck capacity; a half-inch chuck is required.
Do I need cutting fluid when using this high-speed steel bit?
Cutting fluid is not mandatory but strongly recommended to control heat and extend tool life when drilling metal.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
