Cle-Line
Cle-Line C18014 135 Degree Jobber Drill Bit 9/32 in Black & Gold
135-degree split-point jobber drill bit in 9/32 inch high-speed steel with black-and-gold finish for reduced walking and faster chip removal
- TypeDrill Bits
- MaterialHAWA
- 135-degree split point starts cleanly without wandering
- 9/32 inch diameter suits precise fractional sizing
- High-speed steel construction resists heat during drilling
- Black and gold finish identifies the heavy-duty series
- Decimal equivalent 0.2813 in for exact calculations
Cle-Line C18014 Jobber Drill Bit
The Cle-Line C18014 is a jobber length drill bit sized at 9/32 inch for general-purpose drilling tasks. It suits machinists and technicians who need a reliable high-speed steel bit for creating holes in metal and other materials. The black and gold finish identifies the tool in a busy workshop.
135 Degree Split Point Capacity
A 135 degree split point angle centres the bit quickly and reduces walking on hard surfaces. The high-speed steel construction handles standard drilling in steel and alloy workpieces. The non-coolant through design limits use to applications where external lubrication or dry cutting is acceptable.
Black & Gold High Speed Steel Build
The black and gold surface treatment adds wear resistance and helps identify the tool among other accessories. A fractional 9/32 inch size fits standard drill chucks without needing metric conversion. The jobber length provides standard reach for benchtop and handheld drilling operations.
Highlights
- 135-degree split point starts cleanly without wandering
- 9/32 inch diameter suits precise fractional sizing
- High-speed steel construction resists heat during drilling
- Black and gold finish identifies the heavy-duty series
- Decimal equivalent 0.2813 in for exact calculations
Specifications
| Brand | CLE-LINE |
|---|---|
| Type | Drill Bits |
| Material | HAWA |
Questions about this item
Will the 135-degree split point on the 9/32 inch bit start cleanly in the harder steels my older drill press struggles with?
The 135-degree split point is designed to self-center and reduce walking, helping the bit engage hard materials without a center punch even on lower-rigidity machines.
How can I confirm the bit is cutting true after chucking it in my worn keyless chuck?
Drill a test hole in scrap; the split point should produce a centered, round hole with minimal burr and no visible wobble at the shank.
Does the C18014 come with a protective case or just the bare 0.2813-inch black-and-gold bit?
The listing describes only the single jobber-length drill bit; no case, index, or additional accessories are included.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
