Cle-Line
Cle-Line C17061 63/64 in 118 Degree Silver & Deming Drill 1/2 Reduced Shank
A 63/64 in high-speed steel drill bit with a 118-degree point and 1/2 reduced shank for heavy-duty drilling
- TypeDrill Bits
- 63/64 in diameter drills large holes precisely
- 118 degree point angle centres quickly without wandering
- High speed steel construction resists heat during heavy cutting
- Black and gold finish reduces friction and extends bit life
- 1/2 in reduced shank fits standard drill chucks securely
63/64 Inch Silver & Deming Drill
The Cle-Line C17061 is a high-speed steel drill bit with a 118-degree point angle. It features a black and gold finish and a reduced 1/2 inch shank. This accessory fits standard drill chucks for large-hole drilling tasks.
Upgrading from standard twist bits
A reduced shank allows drilling diameters larger than the chuck capacity. The jump is worth it when a project requires a 63/64 inch hole but the drill only accepts 1/2 inch shanks. Standard bits cannot bridge this gap without a larger chuck.
Installing in a drill chuck
Insert the 1/2 inch reduced shank fully into the chuck and tighten securely to prevent slippage. What usually goes wrong is insufficient tightening or misalignment, causing the bit to walk or damage the workpiece during the initial cut.
Highlights
- 63/64 in diameter drills large holes precisely
- 118 degree point angle centres quickly without wandering
- High speed steel construction resists heat during heavy cutting
- Black and gold finish reduces friction and extends bit life
- 1/2 in reduced shank fits standard drill chucks securely
Specifications
| Brand | CLE-LINE |
|---|---|
| Type | Drill Bits |
Questions about this item
Will the 1/2 reduced shank fit my drill chuck?
The 1/2 reduced shank fits any chuck that opens to 1/2 in or larger, so check your chuck capacity before use.
How do I install the bit without it slipping in the chuck?
Open the chuck fully, insert the reduced shank completely, then tighten each jaw evenly by hand before giving a final firm turn with the chuck key.
When will the high-speed steel cutting edges need resharpening?
Resharpen the 118-degree point when drilling force increases noticeably or hole finish becomes rough; a bench grinder or drill-bit sharpener restores the angle.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
