Cle-Line
Cle-Line C17036 19/32 in 118 Degree Silver & Deming Drill 1/2 Reduced Shank
A 19/32 in high-speed steel drill bit with a 118 degree point and 1/2 in reduced shank for general-purpose drilling
- TypeDrill Bits
- MaterialHAWA
- 19/32 in diameter handles large holes
- 118 degree point angle starts cuts cleanly
- 1/2 in reduced shank fits standard chucks
- High speed steel material resists wear
- Black and gold finish protects against corrosion
Cle-Line C17036 19/32 in Drill Bit
The Cle-Line C17036 is a silver and Deming drill bit with a 19/32 inch diameter and a 118 degree point angle. It is built from high speed steel with a black and gold finish for general machining tasks. The 1/2 inch reduced shank allows it to fit standard drill chucks.
Straightforward installation with a standard chuck
Insert the reduced shank into a 1/2 inch capacity chuck and tighten securely before use. The 118 degree point angle starts cleanly in metal without a pilot hole. Applying steady pressure and cutting fluid prevents the bit from wandering or overheating during deep cuts.
Verify chuck capacity and material suitability
Confirm your drill chuck accepts a 1/2 inch shank before ordering this bit. The high speed steel construction is intended for general purpose metal drilling rather than hardened alloys or masonry. Buyers who need a larger diameter or a different point geometry should look elsewhere.
Highlights
- 19/32 in diameter handles large holes
- 118 degree point angle starts cuts cleanly
- 1/2 in reduced shank fits standard chucks
- High speed steel material resists wear
- Black and gold finish protects against corrosion
Specifications
| Brand | CLE-LINE |
|---|---|
| Type | Drill Bits |
| Material | HAWA |
Questions about this item
How can I verify the 118-degree point angle is cutting correctly after installing the bit?
The bit should produce clean, round holes with minimal wandering at the start and consistent chip evacuation in steel when the 118-degree point is working as intended.
What comes with the C17036 and what must I supply separately?
The package includes the 19/32 in Silver & Deming drill with a 1/2 reduced shank; you will need a compatible 1/2 in chuck drill motor and cutting fluid for metalwork.
When should I choose the 19/32 in version over other diameters?
Select the 19/32 in size when your project calls for that exact hole diameter in metal; other diameters are offered for different finished-hole requirements.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
