Cle-Line
Cle-Line 135 Degree Jobber Drill Bit 13/64 in 1801 Steam
A 13/64 inch jobber drill bit with a 135 degree split point made from high speed steel with black oxide finish
- TypeDrill Bits
- MaterialHAWA
- 135-degree split point starts on contact
- High-speed steel body resists wear
- Black oxide finish reduces friction
- 13/64 in diameter matches fractional specs
- Jobber length suits general drilling
Jobber Length Drill Bit 13/64 Inch
This Cle-Line drill bit is a jobber length cutting tool made from high speed steel with a black oxide finish. It features a 135 degree split point design for accurate starts on metal surfaces. The fractional size measures 13/64 inch with a decimal equivalent of 0.2031.
Suited for General Metal Drilling Tasks
This bit suits machinists and maintenance technicians drilling steel and other ferrous materials where a split point helps prevent walking. It is not intended for coolant-fed operations because it has zero coolant holes. Buyers needing through-coolant capability or a different point angle should look at alternative tooling.
135 Degree Split Point Geometry
The defining specification is the 135 degree split point, which centers the bit without a centre punch on hard materials. The high speed steel construction and black oxide finish support durability in repetitive production environments. Verify the 13/64 inch diameter matches your hole requirement before ordering.
Highlights
- 135-degree split point starts on contact
- High-speed steel body resists wear
- Black oxide finish reduces friction
- 13/64 in diameter matches fractional specs
- Jobber length suits general drilling
Specifications
| Brand | CLE-LINE |
|---|---|
| Type | Drill Bits |
| Material | HAWA |
Questions about this item
Will the 13/64 in shank fit a standard three-jaw drill chuck?
Yes, the fractional-inch shank matches common chuck capacities for this diameter.
How do I start a hole with the 135-degree split point without the bit walking?
Apply firm axial pressure at low speed so the split point self-centres before full feed.
When should I replace this high-speed-steel bit?
Replace it when the cutting lips show visible rounding or the black-oxide coating has worn off the flutes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
