Chicago Pneumatic
Chicago Pneumatic Extended Air Angle Grinder 11 In. L
Extended 11-inch pneumatic angle grinder with 1 hp motor, 18,000 rpm free speed, variable speed lever throttle, rear exhaust, and rubber-grip aluminium housing
- Extended reach with 11 in. overall length
- High material removal at 18000 rpm free speed
- Reduced operator fatigue via rubber grip handle
- Versatile speed control with variable speed lever throttle
- Efficient air use at 7.5 CFM average during 15 second run time
Extended Air Angle Grinder 11 In.
This Chicago Pneumatic grinder is an industrial-duty pneumatic tool built for grinding and finishing tasks. It runs at a free speed of 18000 rpm with a 3 in. wheel and a 3/8 in.-24 spindle. The 11 in. overall length provides extended reach for accessing confined work areas. A cast aluminium body with rubber grip and rear exhaust directs air away from the operator.
Metal fabrication and maintenance professionals
The lever throttle with lock and variable speed suit operators who need controlled material removal on metal surfaces. Buyers requiring electric-powered operation or tools for non-industrial occasional use should consider other options. The 90 psi required pressure and 30 CFM full-load demand need a capable compressor setup. This model uses Type 1 grinding wheels, not cone and plug wheels.
11 in. overall length for extended reach
The 11 in. length is the defining dimension that determines access to deep or recessed workpieces. Combined with the 3 in. wheel diameter and 3/8 in.-24 spindle, it sets the tool's physical envelope for specific grinding applications. Verify that this reach matches the clearance requirements of the intended job before purchase.
Highlights
- Extended reach with 11 in. overall length
- High material removal at 18000 rpm free speed
- Reduced operator fatigue via rubber grip handle
- Versatile speed control with variable speed lever throttle
- Efficient air use at 7.5 CFM average during 15 second run time
Specifications
| Brand | Chicago Pneumatic |
|---|
Questions about this item
How do I install the 3/8 In.-24 spindle and what step is often missed?
Fit the supplied flange, nut and wheel guard onto the 3/8 In.-24 spindle using the included wheel nut wrenches; the step often missed is tightening the nut fully before the first run.
What maintenance will the 11 In. extended angle grinder need later?
Lubricate the air motor through the 3/8 In. NPT inlet, drain water from the air line daily, and inspect the rear exhaust and rubber grip for wear.
At what limit does the 18000 rpm grinder stall under sustained load?
The tool demands 30 CFM at full load; if the compressor or 3/8 In. hose cannot supply that flow at 90 psi, speed drops and the grinder stalls.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
