Chicago-Latrobe
Chicago-Latrobe 78599 15/64 in 140 Degree Solid Carbide Straight Flute Drill
Solid carbide straight-flute drill bit with a 140-degree point angle and 15/64 inch diameter
- 15/64 inch size fits precise fractional holes
- 140 degree point angle centres accurately on hard materials
- Solid carbide construction resists wear in abrasive alloys
- Straight flute design clears chips in shallow drilling
- Bright uncoated finish suits general-purpose machining
Chicago-Latrobe 78599 Carbide Drill
The Chicago-Latrobe 78599 is a solid carbide straight flute drill bit sized at 15/64 in with a 140 degree point angle. It suits machinists and maintenance technicians who need a rigid, wear-resistant tool for producing accurate holes in abrasive or hardened materials.
140 Degree Point and Straight Flute Limits
The 140 degree four-facet point centres the cut without a pilot hole, yet the straight flute design does not lift chips from deep cavities. Bright uncoated carbide resists wear but offers no lubricity, so cutting fluid is essential and hole depth is practically limited to the 1 5/16 in flute length.
Upgrade from High-Speed Steel Bits
This bit replaces general-purpose high-speed steel drills when tool life and hole finish matter more than initial cost. The jump is worth it for repeated runs in cast iron, non-ferrous alloys or composites where HSS dulls quickly, but it is not for handheld drilling or interrupted cuts that could fracture the carbide.
Highlights
- 15/64 inch size fits precise fractional holes
- 140 degree point angle centres accurately on hard materials
- Solid carbide construction resists wear in abrasive alloys
- Straight flute design clears chips in shallow drilling
- Bright uncoated finish suits general-purpose machining
Specifications
| Brand | CHICAGO-LATROBE |
|---|
Questions about this item
Is the 15/64 in size the only option for this drill bit?
The 15/64 in size with a .234375 decimal equivalent is the single specification listed for this 78599 model.
How does the 140 degree point angle perform in a real machine?
The 140 degree point angle with a 4 facet design helps centre the bit quickly and reduces walking when drilling into hard materials.
What does the straight flute design mean for chip removal?
Straight flutes on this solid carbide bit are suited for shallow holes and materials producing short chips, requiring frequent withdrawal to clear swarf.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
