Chicago-Latrobe
CHICAGO-LATROBE 52466 118 Degree Silver & Deming Drill 1/2 Reduced Shank pneumatic accessory
118-degree high-speed steel drill bit with 1/2 reduced shank for large-hole drilling
- TypeDrill Bits
- 118° point angle drills accurately in steel
- High-speed steel construction resists heat during extended use
- Black oxide finish reduces friction and chip welding
- 1/2" reduced shank fits standard drill chucks securely
- Model 52466 identifies the exact bit for reordering
Chicago-Latrobe 52466 Drill Bit
This Chicago-Latrobe 52466 drill bit features a 1 1/32 inch diameter with a 1/2 inch reduced shank. The 118 degree point angle suits general-purpose drilling tasks. It is manufactured from high-speed steel with a black oxide finish for durability.
Machinists needing 1 1/32 inch holes
Metalworkers drilling 1 1/32 inch diameter holes in steel or cast iron will find this bit suitable. The reduced shank fits standard 1/2 inch chucks on drill presses or heavy-duty hand drills. Buyers requiring smaller diameters or different shank sizes must select alternative bits.
118 degree point angle
The 118 degree point angle determines how the bit engages the material and clears chips during operation. This geometry is standard for general machining in mild steel and iron. Users drilling hard alloys or needing self-centring performance should verify if a different point angle is required.
Highlights
- 118° point angle drills accurately in steel
- High-speed steel construction resists heat during extended use
- Black oxide finish reduces friction and chip welding
- 1/2" reduced shank fits standard drill chucks securely
- Model 52466 identifies the exact bit for reordering
Specifications
| Brand | CHICAGO-LATROBE |
|---|---|
| Type | Drill Bits |
Questions about this item
Will the 1/2 reduced shank fit my drill chuck?
The 1/2 reduced shank fits any chuck that accepts a 1/2 inch shank diameter.
How do I install the bit without it slipping?
Tighten the chuck fully on the reduced shank section, not on the fluted body, to prevent slippage.
When should I replace the black oxide finish bit?
Replace the high speed steel bit when the 118 degree point becomes dull or the black oxide coating wears away.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
