Chicago-Latrobe
Chicago-Latrobe 49734 17/32 in 118 Degree Taper Length Drill Bit
High-speed steel taper length drill bit with 118-degree radial point in 17/32 inch size
- TypeDrill Bits
- 17/32 in diameter drills large holes
- 118 degree point angle suits general purpose work
- Taper length flute reaches deeper cuts
- High speed steel resists heat buildup
- Black oxide finish reduces friction and corrosion
Chicago-Latrobe 49734 Taper Length Drill Bit
The Chicago-Latrobe 49734 is a taper length drill bit made from high speed steel with a black oxide finish. It is designed for general purpose drilling tasks in a workshop or maintenance environment. The 118 degree radial point helps with centring and reduces walking on contact. This tool suits mechanics and fabricators who need extra reach in a single bit.
17/32 inch capacity with extended reach
The 17/32 inch diameter provides a precise hole size for specific bolt or fastener clearance. Taper length flutes give greater drilling depth than standard jobber bits, allowing deeper holes in one pass. High speed steel offers good wear resistance in mild steel, cast iron and non-ferrous metals. The bit will dull faster in hardened alloys or high-volume production runs.
118 degree radial point geometry
The 118 degree point angle is the deciding factor for material suitability and starting behaviour. It centres reliably on flat surfaces without a centre punch in softer materials. Harder workpieces may require a split point or a different angle to prevent excessive thrust. Choose this bit when the 118 degree geometry matches the application requirements.
Highlights
- 17/32 in diameter drills large holes
- 118 degree point angle suits general purpose work
- Taper length flute reaches deeper cuts
- High speed steel resists heat buildup
- Black oxide finish reduces friction and corrosion
Specifications
| Brand | CHICAGO-LATROBE |
|---|---|
| Type | Drill Bits |
Questions about this item
Will the 17/32 in 118 degree taper length bit fit the chuck on my older 1/2 in drill press?
The 17/32 in diameter shank fits standard 1/2 in chucks, so it will work with older drill presses that accept that capacity.
How can I confirm the 118 degree radial point is cutting correctly after I install the bit?
The bit should produce clean, centred holes with minimal wandering; the black oxide finish reduces friction so chips evacuate smoothly when the point is sharp.
Does the 49734 package include any lubricant or only the high speed steel drill bit itself?
Only the single taper length drill bit is supplied; cutting fluid or lubricant must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
