Chicago-Latrobe
Chicago-Latrobe 44038 19/32 in 118° Jobber Drill Bit
19/32 inch high-speed steel jobber drill bit with 118-degree point for general-purpose drilling
- TypeDrill Bits
- MaterialHAWA
- 19/32 in diameter drills large holes efficiently
- 118° conventional point starts cleanly on contact
- High-speed steel resists wear during repeated use
- Black oxide finish reduces friction and corrosion
- 5938 decimal equivalent simplifies size matching
Chicago-Latrobe 19/32 in Jobber Bit
This Chicago-Latrobe jobber-length drill bit is manufactured from high-speed steel with a black oxide finish. It is engineered for general-purpose drilling across a range of ferrous and non-ferrous materials in maintenance and fabrication shops.
Fits 19/32 in fractional-inch holes
The 118-degree conventional point suits standard drilling operations where a split point or specialised geometry is not required. Buyers needing coolant-through capability or a different point angle should select an alternative tool.
19/32 in diameter with 118-degree point
The fractional size yields a decimal equivalent of .5938 in for precise hole sizing. This specific diameter and point angle determine compatibility with the intended drilling application.
Highlights
- 19/32 in diameter drills large holes efficiently
- 118° conventional point starts cleanly on contact
- High-speed steel resists wear during repeated use
- Black oxide finish reduces friction and corrosion
- 5938 decimal equivalent simplifies size matching
Specifications
| Brand | CHICAGO-LATROBE |
|---|---|
| Type | Drill Bits |
| Material | HAWA |
Questions about this item
What chuck capacity is required for the 19/32 in shank?
A chuck that opens to at least 19/32 in (0.5938 in) will accept the straight shank of this jobber drill bit.
How should the 118° conventional point be started to avoid wandering?
Centre-punch the workpiece, then apply steady axial pressure at low speed until the point engages before increasing RPM.
When does the black-oxide high-speed-steel bit need replacement?
Replace it when the cutting lips no longer produce clean chips after hand honing or when the 118° point angle has worn beyond useful geometry.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
