Chicago-Latrobe
Chicago-Latrobe 44035 35/64 in 118 Degree Jobber Length Drill Bit
A 35/64 inch high-speed steel jobber drill bit with a 118 degree conventional point and black oxide finish for general-purpose drilling
- TypeDrill Bits
- MaterialHAWA
- 35/64 inch diameter drills precise holes
- 118 degree point angle starts quickly in metal
- High speed steel resists wear during use
- Black oxide finish reduces friction and corrosion
- Jobber length provides standard reach and rigidity
Chicago-Latrobe 44035 35/64 in Drill Bit
This Chicago-Latrobe 44035 drill bit is a jobber-length tool sized at 35/64 inch with a 118-degree conventional point. It is made from high-speed steel with a black oxide finish for general-purpose drilling. The fractional size has a decimal equivalent of .5469 inches. It suits machinists and maintenance technicians needing a standard-length bit for common materials.
Replaces worn or undersized jobber bits in 35/64 in
Switch to this bit when an existing 35/64-inch jobber drill shows dull cutting edges or excessive wear at the 118-degree point. The high-speed steel construction restores consistent hole quality in steel and cast iron. The upgrade is worth it when the old bit no longer centres accurately or requires excessive feed pressure to cut.
Check chuck capacity and material suitability
Verify that your drill chuck accepts a straight-shank bit of this diameter and that the machine provides adequate torque for a .5469-inch cutter. The bit has no coolant holes, so it is not suited for through-coolant systems or deep-hole drilling requiring internal lubrication. Confirm the workpiece material matches general-purpose high-speed steel capabilities.
Highlights
- 35/64 inch diameter drills precise holes
- 118 degree point angle starts quickly in metal
- High speed steel resists wear during use
- Black oxide finish reduces friction and corrosion
- Jobber length provides standard reach and rigidity
Specifications
| Brand | CHICAGO-LATROBE |
|---|---|
| Type | Drill Bits |
| Material | HAWA |
Questions about this item
Will a 35/64 in jobber drill fit my standard 1/2 in drill chuck?
The 35/64 in decimal equivalent is .5469, which exceeds a 1/2 in chuck capacity, so a larger chuck or reduced-shank bit is required.
What is the correct way to start a hole with this 118 degree conventional point bit?
Use a centre punch to mark the centre, then apply steady pressure at low speed to prevent the conventional point from wandering on hard surfaces.
When should I replace this high speed steel black oxide drill bit?
Replace the bit when the cutting lips become rounded, the black oxide coating wears off, or the bit overheats and loses hardness during drilling.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
