Chicago-Latrobe
Chicago-Latrobe 44011 11/64 in 118° Jobber Drill Bit
Drills 11/64 in holes with a 118° conventional point in high-speed steel with black oxide finish
- TypeDrill Bits
- MaterialHAWA
- 11/64 in fractional size for precise hole drilling
- 118° conventional point angle starts cleanly on contact
- High-speed steel construction resists wear during use
- Black oxide finish reduces friction and chip welding
- Jobber length design suits general-purpose drilling tasks
Chicago-Latrobe 44011 Jobber Drill Bit
The Chicago-Latrobe 44011 is a jobber length drill bit sized at 11/64 inch with a 118 degree point angle. It is manufactured from high speed steel and features a black oxide finish. The conventional point design suits general purpose drilling tasks. Decimal equivalent is 0.1719 inch.
Suitable for general purpose drilling in metal
This bit suits users needing a standard fractional size for maintenance or fabrication work. The high speed steel construction handles typical ferrous and non-ferrous materials. Builders requiring coolant through capability or specialised coating technologies should look at alternative tooling options. The zero coolant hole design limits deep hole evacuation.
11/64 inch capacity with conventional point geometry
The 11/64 inch diameter provides precise hole sizing for standard fastener clearance or tapping operations. High speed steel offers sufficient wear resistance for moderate production volumes. The 118 degree point centres easily without a pilot hole in most materials. Black oxide finish aids chip flow and reduces galling during extended use.
Highlights
- 11/64 in fractional size for precise hole drilling
- 118° conventional point angle starts cleanly on contact
- High-speed steel construction resists wear during use
- Black oxide finish reduces friction and chip welding
- Jobber length design suits general-purpose drilling tasks
Specifications
| Brand | CHICAGO-LATROBE |
|---|---|
| Type | Drill Bits |
| Material | HAWA |
Questions about this item
What chuck size do I need to hold the 11/64 in shank?
Use a drill chuck that opens to at least 0.1719 in so the straight shank seats fully.
Will the 118° point cut cleanly in the mild steel I already drill with standard bits?
Yes, the conventional 118° point is designed for general-purpose drilling in mild steel and similar materials.
How can I confirm the bit is cutting correctly after the first hole?
Check that the hole diameter matches 0.1719 in and that chips are short, curly and silver-grey.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
