We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Chicago-Latrobe

Chicago-Latrobe 40564 Extension Drill 3/32 x 12 in HSS Black Oxide

SKU CH-FYPY-KNCC0

A 12-inch high-speed steel extension drill with a 135-degree split point and black oxide finish for deep-hole drilling

  • TypeDrill Bits
  • MaterialHAWA
  • 3/32 inch diameter drills precise pilot holes
  • 12 inch overall length reaches deep cavities
  • High Speed Steel construction resists heat buildup
  • 135 degree split point starts on contact

12-Inch Extension Drill for Deep Access

The Chicago-Latrobe 40564 extension drill reaches 12 inches to bore holes in deep or obstructed locations. Its 3/32-inch diameter suits precision fastening and pilot tasks. High-speed steel construction with black oxide finish resists wear during repetitive use. The 135-degree split point starts on contact and reduces walking on hard surfaces.

Low Heat and Stable Power Draw in Hand-Held Use

The black oxide coating lowers friction so the bit runs cooler during extended drilling cycles. Split-point geometry reduces the feed pressure needed, which keeps motor load steady on cordless or corded drivers. No coolant-through design means chips clear through the flutes without extra plumbing. The fractional 0.0938-inch size fits standard three-jaw chucks without adapters.

Highlights

  • 3/32 inch diameter drills precise pilot holes
  • 12 inch overall length reaches deep cavities
  • High Speed Steel construction resists heat buildup
  • 135 degree split point starts on contact

Specifications

BrandCHICAGO-LATROBE
TypeDrill Bits
MaterialHAWA

Questions about this item

How do I install the 40564 extension drill in my drill chuck, and what step do people get wrong?

Insert the 12 in shank fully into the chuck and tighten securely; the step often missed is not seating the split point shank deep enough, which causes runout.

What maintenance or replacement will the 40564 HSS black oxide bit need later?

Resharpen the 135 degree split point when cutting slows; the black oxide coating wears off over time, so replace the bit once the high speed steel shows excessive wear.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.