We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass push-to-connect straight adapter with male pipe threads

CASH ACME

CASH ACME U140LFA 1" x 1" MNPT Brass Trap

SKU CH-A8F1-83TXY MPN U140LFA

Straight male adapter connects 1-inch pipe using push-to-connect brass fitting rated 200 psi and 200 F

  • TypeDrain Components
  • Selling UnitEach
  • Push-to-connect design installs without solder, glue or tools
  • Certified to UPC, IAPMO and NSF-61 standards for potable water
  • Rated 200 psi at 200 °F for reliable service
  • One-piece DZR brass body with ≤ 0.25 % lead on wetted surfaces
  • Removable and reusable with a disconnect clip

Push-to-connect brass adapter for copper PEX CPVC

This 1-inch male NPT adapter uses a push-to-connect design that joins copper PEX or CPVC pipe without solder glue unions or tools. The one-piece DZR brass body is certified to Uniform Plumbing Code IAPMO and NSF-61 standards and rated for 200 psi at 200 F. It is approved for burial and installation behind drywall and can be removed and reused with a disconnect clip.

Tool-free installation with removable clip

Push the pipe into the fitting until it seats and the connection is complete with no open flame or solvent required. A disconnect clip allows the fitting to be released and reused if the pipe is cut square and clean. Debris on the pipe end or an out-of-round tube are the most common causes of leaks so inspect and chamfer the pipe before insertion.

1-inch MNPT size with 200 psi 200 F rating

The single specification that determines fit is the 1-inch male NPT thread combined with a 200 psi pressure rating and 200 F temperature rating. Buyers needing a smaller or larger thread size or a higher pressure class must select a different model.

Highlights

  • Push-to-connect design installs without solder, glue or tools
  • Certified to UPC, IAPMO and NSF-61 standards for potable water
  • Rated 200 psi at 200 °F for reliable service
  • One-piece DZR brass body with ≤ 0.25 % lead on wetted surfaces
  • Removable and reusable with a disconnect clip

Specifications

TypeDrain Components
BrandShark Bite
ModelU140LFA
Selling UnitEach
Shipping weight0.16 kg
Package size54 × 25 × 18 mm

Questions about this item

How can I verify the push-to-connect seal is holding at the rated 200 psi after installation?

Pressurise the line to the working pressure and inspect the joint; the fitting is certified to 200 psi and 200 °F, so a leak-free test at operating pressure confirms the seal.

Does the individually bagged fitting include a disconnect clip for removal, or must I buy one separately?

The fitting is supplied individually bagged; a disconnect clip is not included and must be purchased separately if you need to remove and reuse the adapter.

Which approvals should I match to local code when choosing this 1-inch male adapter?

It carries UPC, IAPMO and NSF-61 certification with a weighted average lead content of 0.25 % on wetted surfaces, meeting typical potable-water code requirements.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.