We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Rectangular rechargeable battery pack with wire connector, grey plastic casing

Cameron Sino Battery for AEMC 6417 Ground Tester, PEL 102, PEL 103 700mAh 8.4V

SKU CH-JGJX-855GG

Rechargeable 700mAh 8.4V replacement pack for AEMC 6417, PEL 102 and PEL 103 ground testers

  • Specifications55.60 x 45.56 x 18.12
  • Battery Pack55.60 x 45.56 x 18.12
  • Battery Capacity700.00 milliamp_hours
  • Battery Voltage8.4 volts
  • Replacement for AEMC 6417, PEL 102 and PEL 103 testers
  • 700 mAh capacity delivers 5.88 Wh at 8.4 V
  • Compact 55.60 × 45.56 × 18.12 mm pack fits original bay
  • ISO 9001, RoHS and CE certified for safety compliance
  • Rechargeable lithium-ion with overcharge, over-discharge and short-circuit protection

Direct Replacement for AEMC Testers

This Cameron Sino battery fits the AEMC 6417 Ground Tester and PEL 102 and PEL 103 models. It matches the original 700mAh capacity and 8.4V voltage so the instrument behaves exactly as it did from the factory. Survey and test professionals who need a fresh power source for field work will find it a direct drop-in.

Upgrade from a Faded Original Cell

It replaces an ageing pack that no longer holds a full charge or that shows reduced run-time during long measurement sessions. The jump is worth it when the original battery drops below useful capacity or when the device shuts down unexpectedly under load. Users whose equipment still meets calibration standards but suffers from short battery life gain the most.

Straightforward Swap with Connector Care

Installation consists of opening the battery compartment, disconnecting the old pack and plugging in the new one using the existing connector. The main pitfall is seating the connector incompletely, which can leave the tester dead on power-up. Following the polarity marks and verifying a firm click avoids the issue.

Highlights

  • Replacement for AEMC 6417, PEL 102 and PEL 103 testers
  • 700 mAh capacity delivers 5.88 Wh at 8.4 V
  • Compact 55.60 × 45.56 × 18.12 mm pack fits original bay
  • ISO 9001, RoHS and CE certified for safety compliance
  • Rechargeable lithium-ion with overcharge, over-discharge and short-circuit protection

Specifications

BrandCameron Sino
Model6417 Ground Tester, PEL 102, PEL 103
Part Number2137.52, 2137.61, 2137.75, 2137.81, 694483
Specifications55.60 x 45.56 x 18.12
Battery Pack55.60 x 45.56 x 18.12
Battery Capacity700.00 milliamp_hours
Battery Voltage8.4 volts

Questions about this item

What are the exact dimensions of the Cameron Sino battery for the AEMC 6417 Ground Tester?

The pack measures 55.60 mm by 45.56 mm by 18.12 mm and weighs 88.0 g.

How do I install the replacement battery in my PEL 102 or PEL 103 tester?

Open the battery compartment, disconnect the old pack, connect the new battery's decoded chip connector firmly, then close the cover; the most common mistake is leaving the connector partially seated.

When will the 700 mAh 8.4 V battery need replacing under normal use?

The manufacturer notes a new pack reaches peak performance after two or three full charge cycles; replace it when run-time on the ground tester drops noticeably below original levels.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.