Caddy
Caddy MSR24 Strap Hanger Angled Clip hardware
Angled strap hanger clips onto flanges and accepts strapping up to 1 1/4 in. wide with a 200 lb load rating
- TypeTarps
- Supports heavy loads with 200 lb rated capacity
- Pre-galvanized spring steel resists corrosion in damp environments
- Hammer-on angled clip installs quickly without tools
- Accepts strapping up to 1 1/4 in wide for versatile mounting
- Metal-detectable construction aids retrieval in food or industrial lines
Strap Hanger Angled Clip
The NVENT CADDY MSR24 is a steel strap hanger designed to support pipe or duct from a flange using banding or strapping. It accepts strap up to 1 1/4 in. wide and is built for structural mounting tasks. The pre-galvanized spring steel construction provides corrosion resistance for indoor and outdoor installations. It is suited for mechanical contractors and maintenance crews securing services to building steel.
Pre-Galvanized Steel Construction
The clip is formed from pre-galvanized spring steel that resists rust without adding bulk or weight. Its hammer-on design seats onto flanges without drilling, preserving the integrity of the host structure. Metal detectable material aids identification during inspections or recovery. The 200 lb maximum load rating covers typical conduit, cable tray and light duct runs.
Replaces Welded Or Bolted Brackets
This hanger eliminates the need for field welding or through-bolting when attaching services to beam flanges. The upgrade is worth it on projects where hot-work permits are difficult or where speed of installation reduces labour cost. It is not suited for loads exceeding the rated capacity or for applications requiring adjustable drop lengths.
Highlights
- Supports heavy loads with 200 lb rated capacity
- Pre-galvanized spring steel resists corrosion in damp environments
- Hammer-on angled clip installs quickly without tools
- Accepts strapping up to 1 1/4 in wide for versatile mounting
- Metal-detectable construction aids retrieval in food or industrial lines
Specifications
| Brand | NVENT CADDY |
|---|---|
| Type | Tarps |
Questions about this item
How do I hammer the angled clip onto a flange without bending the spring steel?
Position the clip on the flange edge, then strike the top of the clip squarely with a hammer until the teeth grip the metal; do not hit the strap loop or the angled tab, as off-centre blows can deform the pre-galvanized spring steel and reduce the 200 lb load rating.
Will the pre-galvanized coating need touch-up if the clip is used outdoors?
The pre-galvanized spring steel resists corrosion in normal indoor and sheltered outdoor environments; if the coating is scratched during installation, apply a cold-galvanizing spray to the exposed steel to maintain protection.
What happens if the supported load exceeds the 200 lb limit over time?
Sustained loads above 200 lb can cause the spring steel to take a permanent set, reducing grip on the flange and allowing the strap to slip; the clip is designed for a maximum of 200 lb.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
