We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Bronze flanged sleeve bearing with 3/4 inch bore and self-lubricating finish

Bunting Bearings

Bunting Bearings EF121624 flanged sleeve bearing 3/4 in bore bronze self-lubricating PK3

SKU CH-XP3N-2NERS

Self-lubricating bronze flanged sleeve bearing with 3/4 in bore and 1.25 in flange diameter

  • Self-lubricating bronze eliminates external oiling
  • 3/4 inch bore fits standard shafts
  • Flanged design secures axial positioning
  • Operates from 10 to 220 degrees F
  • SAE 30 oil impregnation ensures steady lubrication

Flanged sleeve bearing 3/4 in bore

This flanged sleeve bearing has a 3/4 in bore and 1 in outside diameter with a 1 1/2 in overall length. The bronze body uses sintered bronze material and carries SAE 30 oil for self-lubricating operation. It is sold as a pack of three units.

Bronze material and self-lubricating oil

The bronze construction and internal SAE 30 oil remove the need for external grease lines in many low-speed applications. The flanged design with a 1.25 in flange diameter and .187 in flange thickness provides axial location without separate thrust washers.

Check shaft tolerance and temperature range

Verify that the shaft diameter matches the 3/4 in bore and that the housing can accept the 1 in outside diameter with the stated length tolerance of +/- .0075 in. The bearing is rated for a minimum temperature of 10 Degrees F and a maximum of 220 Degrees F.

Highlights

  • Self-lubricating bronze eliminates external oiling
  • 3/4 inch bore fits standard shafts
  • Flanged design secures axial positioning
  • Operates from 10 to 220 degrees F
  • SAE 30 oil impregnation ensures steady lubrication

Specifications

No published specifications for this item yet.

Questions about this item

When will the bronze bearing and SAE 30 oil need replacing?

The sintered bronze is self-lubricating with SAE 30 oil, so no routine oil changes are required; replace the bearing if clearance grows beyond the .0075 in length tolerance or if wear causes excess play.

What is the first limit reached during continuous operation?

The maximum operating temperature is 220 Degrees F; sustained loads that push the bearing beyond this limit will degrade the oil film before any dimensional limit is hit.

How much heat and noise does the flanged sleeve produce when running all day?

Bronze-on-steel with SAE 30 oil runs quietly; the bearing itself generates minimal heat, but the housing must dissipate enough to keep the bore below 220 Degrees F.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.