Brady
Brady key control ALU-RED-76ST-KD6PK padlock aluminum red 3 in shackle keyed different
Aluminium lockout padlock with 3-inch steel shackle, anodised red body and keyed-different cylinders for multi-point isolation
- 3 in shackle clears wide lockout points
- Keyed different gives each lock a unique key
- Anodized aluminum body resists corrosion
- Steel shackle adds cut resistance
- Red color with Danger header for quick identification
Brady key control aluminum padlock
This Brady padlock is an anodized aluminum lockout device with a red body and a 3 in steel shackle. It is built for industrial lockout procedures where each lock must open with its own unique key. The corrosion‑resistant finish suits harsh environments and the linear keyway prevents accidental duplication.
Keyed different six pack for multi person lockout
The pack contains six locks keyed differently so every authorised worker carries a personal key. This replaces a single keyed alike set when a procedure demands individual accountability and no master key access. The jump is worth it whenever a site audit requires proof that only the assigned person can remove their lock.
Simple shackle insertion with one common snag
Installation is a matter of inserting the 1/4 in shackle through the isolation point and snapping the body shut; the key stays captive until the lock is opened. The most frequent issue is debris jamming the linear keyway in dirty plant areas, so a quick blast of compressed air before use keeps the mechanism reliable.
Highlights
- 3 in shackle clears wide lockout points
- Keyed different gives each lock a unique key
- Anodized aluminum body resists corrosion
- Steel shackle adds cut resistance
- Red color with Danger header for quick identification
Specifications
| Brand | Brady |
|---|
Questions about this item
What body width and shackle clearance does the ALU-RED-76ST-KD6PK need for the hasp or chain link?
The padlock body is 1 1/2 in wide and the shackle clears 13/16 in horizontally and vertically, so the attachment point must accept a 1/4 in shackle within that 13/16 in gap.
How do I fit the keyed-different cylinders into a master-keyed system without mixing the six unique keys?
Each of the six padlocks comes with its own linear key; install them by assigning one distinct key per lock and recording the key codes so no two locks share a key.
When should I replace the anodized aluminum body or steel shackle due to corrosion wear?
Inspect the anodized coating and steel shackle regularly; replace the padlock if the red anodizing flakes away or the shackle shows pitting that prevents full engagement.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
