BoYata
BoYata N Female 3 Way Power Splitter 380-2500MHz 50 Ohm 2 in 1 Accessory
Three-way N-female splitter divides one 380–2500 MHz signal into three 50-ohm outputs with 6.4–9 dB insertion loss
- Splits one antenna signal to three N female ports
- Wide 380-2500MHz range suits cable, antenna and satellite links
- Low 1.1 to 2.3 VSWR keeps reflections minimal across the band
- Rugged aluminium alloy body with copper connectors handles 50 W input power
- Compact 14 x 7.8 x 3.3 cm size weighs only 265.1 g
3-Way N Female Power Splitter
The BoYata N female three-way power splitter accepts a single input and distributes the signal across three N female output ports. It operates across a 380 to 2500 MHz frequency range with a 50 Ohm impedance rating. The aluminium alloy body and copper connectors are rated for up to 50 W of power capacity.
Installers needing one-to-three distribution
This splitter suits RF installers who need to feed three antennas or cables from a single source within the specified frequency band. It is not for buyers who require a different connector type such as SMA or BNC, nor for systems that demand lower insertion loss than the 6.4 to 9.0 dB specified here.
50 Ohm impedance match
The 50 Ohm impedance is the critical specification that determines compatibility with the coaxial cable and antenna system in use. Mismatched impedance will cause reflections and degrade signal quality across the 380 to 2500 MHz operating range.
Highlights
- Splits one antenna signal to three N female ports
- Wide 380-2500MHz range suits cable, antenna and satellite links
- Low 1.1 to 2.3 VSWR keeps reflections minimal across the band
- Rugged aluminium alloy body with copper connectors handles 50 W input power
- Compact 14 x 7.8 x 3.3 cm size weighs only 265.1 g
Specifications
No published specifications for this item yet.
Questions about this item
What cables or antennas with N male connectors do I need to connect to the splitter's three N female outputs?
You need three cables or antennas terminated with N male plugs to mate with the three N female output ports on the splitter.
Can I feed the splitter from an existing 50 ohm coaxial run that already has an N male termination?
Yes, the splitter's single N female input accepts an N male plug from any 50 ohm coaxial cable within the 380 to 2500 MHz range.
How can I verify the splitter is performing correctly after installation?
Measure insertion loss between 6.4 and 9.0 dB, isolation near 20 dB, VSWR within 1.1 to 2.3, and amplitude balance around 0.3 dB across the operating band.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
