BoYata
BoYata 25G SFP28 LR 1310nm 10km LC SMF 2 in 1 accessory
A 25G SFP28 LR transceiver reaches 10 km over single-mode fibre at 1310 nm with duplex LC connectors
- 25 Gbps throughput over single-mode fibre up to 10 km
- Digital optical monitoring via I2C compliant with SFF-8472
- RS-FEC and FC-FEC support for error-resilient links
- Duplex LC receptacle fits standard single-mode patch cords
- Compatible with CPRI option 10 at 24.33 Gbps
25G SFP28 LR 10km Module
This 25G SFP28 LR transceiver operates at 1310nm over single-mode fibre with a duplex LC connector. It supports links up to 10km and is compatible with the Ubiquiti UACC-OM-SFP28-LR. The module complies with SFP28 MSA and SFF-8472 standards, with diagnostics available via I2C. It suits network engineers extending 25G Ethernet or CPRI option 10 at 24.33Gbps.
Replaces 10G or Short-Range 25G Optics
The jump is worth it when existing 10G links saturate or when 25G SR modules cannot reach the required distance. This LR variant covers 10km, supporting 25GBASE-LR Ethernet and 25GBASE at 25.78Gbps alongside CPRI option 10. It also enables RS-FEC and FC-FEC for improved link integrity. Buyers needing only a few metres or multimode fibre should choose a different module.
Hot-Plug Install with I2C Diagnostics
Installation is a hot-plug insertion into any compliant SFP28 cage; no tools or configuration are required. The duplex LC connector must match single-mode patch cables polished for 1310nm. What usually goes wrong is mixing single-mode and multimode fibre, exceeding the 10km budget, or disabling FEC on noisy links. SFF-8472 data over I2C helps verify signal quality after install.
Highlights
- 25 Gbps throughput over single-mode fibre up to 10 km
- Digital optical monitoring via I2C compliant with SFF-8472
- RS-FEC and FC-FEC support for error-resilient links
- Duplex LC receptacle fits standard single-mode patch cords
- Compatible with CPRI option 10 at 24.33 Gbps
Specifications
No published specifications for this item yet.
Questions about this item
Does the SFP28 module fit a standard SFP28+ MSA slot with a duplex LC receptacle?
Yes, the module complies with the SFP28+ MSA and SFF-8472 standards and uses a duplex LC receptacle for single-mode fibre.
What is the correct way to insert the module and connect the LC cables without damaging the latch?
Align the module with the cage, slide it in until the latch clicks, then insert the LC connectors straight in until they lock; pulling cables at an angle can break the latch.
When should the optical transceiver be replaced if link errors appear on a 10 km single-mode run?
Replace the module if DOM monitoring via the I2C interface shows rising Rx power alarms or persistent CRC errors on the 25GBASE-LR or CPRI option10 24.33Gbps link.
New to this? Buying a laptop with crypto, start to finish — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
