BONAEVER
BONAEVER 2 Pack 90 Degree ATX 8P EPS Male to Female Adapter 12V
Two right-angled ATX 8-pin EPS adapters reroute CPU power cables 90 degrees for tight chassis clearance
- TypeOthers
- Redirects CPU power cables 90° for tight clearances
- Up-angled and down-angled pair clears heatsink or VRM obstacles
- Low-profile design fits shallow chassis without cable strain
- Two adapters included for dual-CPU or redundant routing
- Keyed EPS 8-pin male-to-female prevents mis-connection
CPU power cable adapter for tight builds
The BONAEVER 90 Degree ATX 8P EPS adapter changes the cable routing direction on a motherboard CPU power header. Each pack contains two angled pieces, one pointing up and one pointing down, to fit different board layouts. It is made for builders working in limited-height chassis where a straight connector will not fit.
Replaces a straight EPS header plug
Use this adapter when the stock cable exits vertically but clearance above or below the socket is too tight. The 90 degree bend lets the wire run horizontally along the board instead. The jump is worth it whenever the case roof, a large cooler or a rear fan blocks the standard connector orientation.
Check header keying and device type
Verify the motherboard uses an 8-pin EPS 12V header before ordering; this adapter will not work with PCI-E power sockets for graphics cards. Ensure the male and female keying on both the board and the power supply cable match the ATX EPS standard. No other compatibility checks are required.
Highlights
- Redirects CPU power cables 90° for tight clearances
- Up-angled and down-angled pair clears heatsink or VRM obstacles
- Low-profile design fits shallow chassis without cable strain
- Two adapters included for dual-CPU or redundant routing
- Keyed EPS 8-pin male-to-female prevents mis-connection
Specifications
| Type | Others |
|---|
Questions about this item
Does the 90 degree ATX 8P EPS adapter clear the CPU cooler in a low-profile case?
The angled header re-routes the CPU power cable from vertical to horizontal, and the pack includes both up-angled and down-angled versions to fit either side of the socket.
How do I install the BONAEVER 12V EPS adapter without bending the motherboard pins?
Align the keyed male connector with the motherboard's 8-pin EPS socket, press straight down until seated, then attach the existing CPU power cable to the female end.
Will the adapter contacts degrade if I leave it installed for years?
The gold-plated pins resist oxidation, so no periodic maintenance is required; replace only if physical damage occurs.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
